Your service tire monitor light tells you the tire pressure monitoring system has detected a problem, but not necessarily that your tires are flat

The service tire monitor light (sometimes called the TPMS warning light) appears on your dashboard when your vehicle's tire pressure monitoring system detects that one or more tires are underinflated, overinflated, or when a sensor has failed. The light looks different depending on your vehicle — it may show a tire with an exclamation mark, the letters "TPMS," or a tire with a pressure gauge symbol. Unlike a check engine light, this is not an emergency stop signal, but it does mean you need to check your tires soon.

The system monitors air pressure in each tire and alerts you when pressure drops below or rises above the manufacturer's recommended range. Most vehicles have one sensor per tire, though some older systems use a spare sensor that rotates. The light typically turns on when tire pressure is about 25% below the recommended PSI, which means you might not notice a slow leak by feel alone.

Key Takeaways

  • The service tire monitor light means at least one tire is underinflated, overinflated, or a sensor has malfunctioned — not necessarily that you have a flat tire.
  • Check your tire pressure with a gauge at a gas station or tire shop within a day or two; the recommended PSI is on a sticker inside your driver's door, not on the tire sidewall.
  • Temperature changes cause tire pressure to fluctuate, so the light often appears in fall or winter when it gets cold.
  • If pressure is correct but the light stays on, a sensor battery has likely died or a sensor is damaged, and you will need a replacement at a tire shop or dealership.
  • Driving with significantly underinflated tires reduces fuel economy, causes uneven wear, and can overheat the tire, so address the problem within a few days.

How to check your tire pressure when the light comes on

First, locate the correct tire pressure for your vehicle. Open your driver's side door and look for a sticker on the inside of the door frame — this shows the manufacturer's recommended PSI for both front and rear tires. Do not use the maximum PSI printed on the tire sidewall; that is the tire's limit, not your vehicle's requirement. The recommended pressure is usually between 28 and 35 PSI depending on your vehicle.

Next, get a tire pressure gauge. Most gas stations have free air pumps with built-in gauges, and tire shops will check pressure for free. Remove the valve cap from each tire (keep them in your pocket so you do not lose them), press the gauge onto the valve stem, and read the pressure. Write down all four readings. If one or more tires are 3 PSI or more below the recommendation, add air at the gas station pump. If a tire is overinflated, let a small amount of air out by pressing the valve stem with your finger.

After adjusting pressure, drive for a few minutes and check again — sometimes the reading changes slightly as the tire warms up. If all four tires are now at or very close to the recommended pressure and the light does not turn off within a day or two of driving, move to the sensor replacement section below.

Why the light appears in cold weather and how temperature affects pressure

Tire pressure drops in cold weather because air contracts as temperature falls. For every 10-degree Fahrenheit drop in outside temperature, tire pressure typically decreases by about 1 PSI. This means your service tire monitor light often appears in fall or early winter even if your tires were fine in summer. The reverse happens in spring — pressure rises as it warms up, and the light may turn off on its own.

This is normal and not a sign of a leak. Check your tire pressure and adjust it to the recommended level. As the season changes and temperatures stabilize, the light should stay off. If the light comes back on during the next cold snap, you can repeat the same process. Some drivers keep a tire gauge in their glove box to check pressure before the light appears, especially if they live in a climate with big temperature swings.

What to do if tire pressure is correct but the light stays on

If all four tires are at the correct pressure and the light remains on for more than a day or two of driving, one of your tire pressure sensors has likely failed. TPMS sensors run on small batteries that last 5 to 10 years depending on the vehicle and sensor type. When a battery dies, the sensor stops sending a signal to your vehicle's computer, and the light stays on even though your tires are fine.

A failed sensor does not make your tires unsafe — it just means you lose the early warning system for pressure problems. However, you should replace the sensor within a few weeks so you have that protection again. Take your vehicle to a tire shop or dealership and tell them the service tire monitor light is on. They will use a diagnostic tool to identify which sensor is not responding, and then replace that sensor. Replacement typically costs between $50 and $150 per sensor depending on your vehicle and where you go.

Some shops will replace all four sensors at once if multiple batteries are aging, which can be more cost-effective than replacing them one at a time over the next few years. Ask the shop whether they recommend this based on your vehicle's age and sensor type.

Slow leaks and when to have a tire inspected

If the service tire monitor light comes on and one tire is noticeably lower than the others — for example, 5 or more PSI below the recommended level — you may have a slow leak. Add air to bring it to the correct pressure, but plan to have that tire inspected at a tire shop within a few days. A slow leak can be caused by a puncture, a damaged valve stem, or a bead leak where the tire does not seal properly against the rim.

A tire shop can inspect the tire visually and use a soapy water test to find the leak. If the leak is in the tread, the tire can usually be patched for $10 to $25. If the leak is in the sidewall or at the bead, the tire cannot be safely repaired and will need to be replaced. Addressing a slow leak quickly prevents the tire from losing pressure while you are driving, which can cause the tire to overheat and fail.

If the same tire keeps losing pressure even after a patch, or if you cannot find the source of the leak, the tire may have internal damage and should be replaced rather than repaired.

Tire pressure monitoring system types and what they mean for you

Most vehicles made after 2008 have direct TPMS, which uses a sensor in each tire to measure pressure and send the reading to your vehicle's computer. Some older or budget vehicles use indirect TPMS, which estimates tire pressure by comparing wheel speed data from your anti-lock brake system. Indirect systems are less accurate and cannot tell you which tire is low — they only turn on the light if one tire is significantly underinflated.

If your vehicle has indirect TPMS and the light comes on, you will need to check all four tires manually with a gauge to find the low one. If your vehicle has direct TPMS, some models will display which tire is low on the dashboard or in the instrument cluster, while others only show the light. Check your owner's manual or ask your dealer if your vehicle displays individual tire pressures.

Frequently Asked Questions

Can I drive with the service tire monitor light on?

Yes, but only for a short distance to reach a gas station or tire shop. If one tire is significantly underinflated, driving on it can overheat the tire and cause a blowout. Check your tire pressure and adjust it as soon as you can, ideally within a few hours.

Does the light mean I have a flat tire?

Not necessarily. The light turns on when pressure is about 25% below recommended, which is noticeable but not a flat. If a tire is completely flat, you will feel it when ready — the vehicle will pull to one side and the steering will feel heavy. A flat tire is different from the service tire monitor light.

Why does the light come on after I fill my tires?

You may have overfilled them. Check the pressure with a gauge and let out air if needed to match the recommended PSI on your door sticker. Overinflated tires can also trigger the light and cause uneven wear in the center of the tread.

How much does it cost to replace a TPMS sensor?

A single sensor replacement typically costs $50 to $150 at a tire shop or dealership, depending on your vehicle make and model. Some shops charge less for the sensor itself but add a labor fee for installation and rebalancing.

Will the light turn off on its own if I just ignore it?

No. If the light is on because of a failed sensor, it will stay on until the sensor is replaced. If it is on because of low pressure, it will stay on until you add air. Ignoring it means you lose the warning system for future pressure problems.