When and how to replace a tyre
You can replace a tyre yourself if you have a spare, a jack, a lug wrench, and about 15 to 30 minutes. The process is: loosen the lug nuts while the car is still on the ground, raise the car with the jack, remove the lug nuts completely, pull the old tyre straight toward you, mount the new tyre onto the wheel studs, hand-tighten the lug nuts, lower the car, and tighten the lug nuts in a star pattern with the wrench. After driving a few miles, stop and tighten them again — they often settle.
You do not need to replace a tyre yourself. A tyre shop, petrol station, or car repair garage will do it for you, usually while you wait. The cost varies by location and tyre type, but expect to pay between £15 and £50 per tyre for labour alone if you bring your own tyre, or more if you buy the tyre from them. If you are uncomfortable with the process, unsure about your spare, or driving a vehicle you do not know well, a professional replacement is the safer choice.
Key Takeaways
- A roadside tyre change requires a spare tyre, jack, and lug wrench, and takes 15 to 30 minutes if you have done it before.
- Loosen lug nuts before raising the car, and tighten them again in a star pattern after lowering — skipping either step is a common cause of problems.
- A tyre shop or garage can replace a tyre for you in under an hour, and the cost depends on whether you bring your own tyre or buy one from them.
- Check your spare tyre's condition and pressure before you need it; a flat or damaged spare is useless in an emergency.
- If your spare is a temporary (donut) tyre, drive no faster than 50 mph and no more than 70 miles before getting a full-size replacement.
Tools and equipment you need
A jack is the tool that lifts your car off the ground. Most cars come with a scissor jack in the boot. Check your owner's manual to find where it is and how to use it — different vehicles have different attachment points, and using the wrong one can damage the car. Some people prefer a bottle jack or floor jack because they are easier to use, but the scissor jack that came with your car will work.
A lug wrench is a metal tool with four sockets of different sizes, one of which will fit your car's lug nuts. It usually comes with the jack. If you cannot find it, a replacement costs £5 to £15 at any petrol station or car parts shop. Do not try to loosen lug nuts by hand — the wrench gives you the leverage you need.
A spare tyre is either a full-size tyre that matches your other three, or a temporary (donut) tyre that is smaller and thinner. Full-size spares are safer and last longer, but take up more boot space. Temporary spares are lighter and cheaper, but you should not drive faster than 50 mph or more than 70 miles on one. Check your spare's pressure and condition before you need it — a flat spare is useless, and a cracked or bulging one should be replaced.
You may also want a torch if you are changing a tyre in the dark, and a pair of gloves to keep your hands clean. Neither is essential, but both make the job easier.
Step-by-step process for changing a tyre
Step 1: Move to a safe location. If you have a puncture while driving, do not stop in the middle of a motorway or a blind curve. Drive slowly to a flat, wide shoulder, a car park, or a quiet street. Turn on your hazard lights and, if you have one, place a warning triangle 45 metres behind your car.
Step 2: Loosen the lug nuts. Before you raise the car, use the lug wrench to loosen (but do not remove) each lug nut by a quarter turn. The car's weight makes this easier. If a nut is stuck, do not force it — spray it with penetrating oil, wait a few minutes, and try again. If it still will not budge, call a breakdown service rather than risk stripping the nut.
Step 3: Raise the car. Position the jack under the car's frame near the tyre you are replacing. Check your owner's manual for the exact spot — it is usually a reinforced section near the wheel well. Raise the car until the tyre is about 15 centimetres off the ground. Make sure the car is stable and will not roll.
Step 4: Remove the lug nuts and old tyre. Unscrew the lug nuts the rest of the way by hand and set them somewhere you will not lose them — a cup or small container works well. Grip the tyre with both hands and pull it straight toward you. It may be tight; rock it gently side to side if it does not come free when ready.
Step 5: Mount the new tyre. Align the holes in the new tyre with the wheel studs and push it onto the studs until it sits flush against the wheel. Hand-tighten the lug nuts in the order they sit — if the studs are at 12, 3, 6, and 9 o'clock, tighten them 12, 6, 3, 9. This keeps the tyre centred.
Step 6: Lower the car and tighten fully. Lower the car slowly until the tyre touches the ground and the car's full weight is on it. Now use the lug wrench to tighten the lug nuts in the same star pattern, explore firm pressure but not maximum force — you want them snug, not stripped. Lower the car completely and remove the jack.
Step 7: Check and re-tighten. Drive a few miles at normal speed, then stop and check the lug nuts again with the wrench. They often loosen slightly as the tyre settles. If any are loose, tighten them again.
Common mistakes that cause problems
The most common error is tightening lug nuts while the car is still in the air. When you do this, the tyre can spin freely, and you may tighten some nuts more than others. This causes the tyre to sit unevenly and can damage the wheel. Always tighten lug nuts after the car is back on the ground and bearing its own weight.
Another frequent mistake is forgetting to re-tighten the lug nuts after driving. Lug nuts naturally loosen as the tyre settles into place. If you do not tighten them again within the first few miles, they can come loose completely, and the tyre can fall off. This is dangerous and expensive to fix.
Using the wrong jack attachment point can bend or crack the car's frame. Always check your owner's manual before raising the car. If you are unsure, ask a mechanic or call your breakdown service — it takes five minutes and is worth the peace of mind.
Driving too fast or too far on a temporary spare is also risky. These tyres are designed for short journeys at low speeds. If you drive a temporary spare at motorway speeds for 100 miles, it can overheat, fail, and leave you stranded again.
When to take your car to a professional
If your spare tyre is flat, damaged, or missing, do not attempt a roadside change. Call your breakdown service (such as the AA or RAC) and they will either repair your tyre on the spot or tow you to a garage. This is what breakdown cover is for.
If a lug nut is stuck and will not loosen after spraying with penetrating oil, a professional has better tools and experience to remove it without stripping it. Stripped lug nuts are expensive to fix and can make the wheel unsafe.
If you are not confident in your ability to use a jack safely, or if you are changing a tyre in heavy traffic, darkness, or bad weather, a professional is the better choice. There is no shame in this — roadside tyre changes are stressful and risky in poor conditions.
If your car has a run-flat tyre (a tyre designed to keep working even when punctured), check your owner's manual before attempting a change. Some run-flat systems require special handling, and a garage may be safer.
Checking your spare tyre before you need it
Check your spare tyre's pressure at least once a month using a pressure gauge. You can buy a basic gauge for £3 to £10 at any petrol station. The correct pressure is printed on a label inside the driver's door frame or in your owner's manual — it may be different from your regular tyres' pressure. If the spare is low, inflate it at a petrol station air pump.
Inspect the spare visually for cracks, bulges, or uneven wear. If you see any damage, replace the spare before you need it. A damaged spare is worse than no spare at all because you might not realise it is unusable until you have a puncture.
If you have a temporary spare, check that it is still in your boot. Some people remove them to make space and forget to replace them. If yours is missing, buy a replacement at a tyre shop or online — they cost £30 to £80 depending on your car's size.
Frequently Asked Questions
Can I change a tyre in the rain or on a motorway?
You can, but it is riskier. Rain makes the ground slippery and the jack less stable. On a motorway, passing traffic creates wind and vibration that can destabilise the car. If possible, drive slowly to a safer location — a service station, car park, or quiet road. If you cannot, turn on your hazard lights, place a warning triangle, and work as quickly as you can. If you feel unsafe, call your breakdown service instead.
What if I do not have a spare tyre?
Call your breakdown service. They will either repair your puncture on the spot or tow you to a garage. This is why breakdown cover is valuable — it covers situations where you cannot change the tyre yourself. If you do not have breakdown cover, you can call a local tyre shop or garage and ask if they offer a mobile repair service.
How tight should lug nuts be?
Tight enough that you cannot loosen them by hand, but not so tight that you need to strain with the wrench. A good rule is to tighten until you feel firm resistance, then give the wrench a quarter turn more. Over-tightening can strip the studs or warp the brake rotor. If you are unsure, a garage can tighten them to the correct torque specification for your car.
Is it safe to drive on a patched or plugged tyre?
A professional patch or plug is safe for the rest of the tyre's life, as long as the puncture is in the tread (not the sidewall) and smaller than 6 millimetres. A tyre shop can assess whether your puncture is repairable or if the tyre needs replacing. Sidewall punctures and large holes cannot be safely repaired and require a new tyre.
Do I need to balance my tyre after changing it?
If you are using a spare that has been sitting in your boot, it may be out of balance. You will notice vibration in the steering wheel or seat at certain speeds. A tyre shop can balance it for £10 to £20 per tyre. If the spare is new or was recently balanced, you may not need it done when ready, but have it checked at your next service.