What you need before you start
Changing a flat tire takes about 15 to 30 minutes if you have the right tools and a safe place to work. You will need a spare tire (check that it holds air), a jack (usually comes with your car), a lug wrench (the cross-shaped tool that fits your wheel bolts), and wheel wedges or heavy objects to block the wheels. A flashlight helps if you are on the road at night, and work gloves protect your hands from dirt and sharp edges.
Before you change the tire, move your car to a flat, stable surface away from traffic if possible. Turn on your hazard lights. If you are on a highway, pull as far from the road as you can. Do not attempt a tire change on a steep hill or soft shoulder where the car might roll.
Check your spare tire now, not when you have a flat. A spare that has lost air is useless. If your spare is flat or missing, call roadside information or a tow truck instead of attempting the change yourself.
Key Takeaways
- Loosen the lug nuts while the tire is still on the ground, then raise the car with the jack before removing the wheel completely.
- The spare tire goes on the same bolts as the flat tire; hand-tighten the lug nuts first, then lower the car and tighten them fully with the wrench.
- A temporary or compact spare tire should not be driven faster than 50 mph or for more than 70 miles; have the flat tire repaired or replaced as soon as possible.
- If the lug nuts are stuck, the jack slips, or you cannot break the tire loose from the rim, stop and call for roadside information rather than risk injury.
Loosen the lug nuts before lifting the car
Place the lug wrench on each bolt and turn it counterclockwise to loosen the nuts. Do this while all four wheels are on the ground—the car's weight holds the wheel steady and prevents it from spinning. You do not need to remove the nuts completely yet, just loosen them enough that you can turn them by hand once the car is raised.
If a lug nut will not budge, try wrapping a cloth around the wrench for better grip, or tap the wrench gently with a hammer to break the corrosion. Do not use your full body weight to force it; if it truly will not move, this is a sign to call for help rather than risk stripping the bolt or injuring yourself.
Raise the car with the jack
Locate the jacking point on your car—this is usually a reinforced notch or flat spot on the frame near each wheel. Consult your owner's manual if you are unsure where it is. Position the jack directly under this point, not under the plastic trim or bumper, which will crack.
Pump or turn the jack handle to raise the car until the flat tire is about six inches off the ground. Raise it slowly and watch for any sign that the jack is slipping or the car is tilting. Once the car is up, place wheel wedges or heavy blocks behind the wheels that are still on the ground to prevent the car from rolling.
Remove the flat tire and install the spare
Now finish unscrewing the lug nuts by hand and set them aside in a safe place where you will not lose them. Pull the flat tire straight toward you to remove it from the bolts. It will be heavy; brace yourself or ask someone to help.
Lift the spare tire onto the bolts and push it all the way in until the bolt holes line up. Hand-tighten the lug nuts onto the bolts in a crisscross pattern (top, bottom, left, right, then the remaining one). This keeps the wheel centered. Do not use the wrench yet; hand-tight is enough for now.
Lower the car and tighten the lug nuts fully
Slowly lower the car by turning the jack handle in the opposite direction. Lower it until the spare tire is fully supporting the car's weight and the jack is no longer holding it up. Remove the jack.
Now use the lug wrench to tighten each lug nut fully, again in a crisscross pattern. Tighten firmly but do not over-tighten, which can strip the bolts or make removal difficult later. A good rule is to tighten until you feel solid resistance, then give it one more quarter turn.
Stow the flat tire and drive carefully
Place the flat tire, jack, and lug wrench back in your trunk or cargo area. If you have a full-size spare, you can drive normally to a tire shop. If you have a compact or temporary spare (the smaller donut-shaped tire), follow the speed and distance limits printed on its sidewall—usually 50 mph maximum and 70 miles maximum. Driving faster or farther can damage the spare and leave you stranded again.
Have the flat tire inspected and repaired or replaced within a day or two. A puncture in the tread can sometimes be patched for $10 to $20, but sidewall damage means the tire must be replaced. Once the flat is fixed, put it back in your car as your spare.
When to call for roadside information instead
Do not attempt a tire change if the lug nuts are seized and will not loosen, if the jack is damaged or slipping, if the car is on a steep slope or unstable surface, or if you are on a busy highway where standing outside is unsafe. Call roadside information, your roadside coverage provider, or a tow truck. Many auto insurance policies include roadside information at no extra cost; check your policy documents or call your insurer to confirm.
If you are uncomfortable with the process or unsure about any step, it is better to wait for professional help than to risk dropping the car or injuring yourself. Roadside information typically arrives within 30 to 60 minutes in urban areas, longer in rural locations.
Frequently Asked Questions
Can I change a tire in the rain or on wet pavement?
Yes, but it is riskier. Wet pavement reduces traction and makes the jack more likely to slip. If possible, wait for the rain to stop or move to a drier spot. If you must change the tire in wet conditions, work slowly, double-check that the jack is stable, and place wheel wedges behind the wheels to prevent rolling.
What if I lose a lug nut while changing the tire?
You can drive to a tire shop or auto parts store with three lug nuts holding the wheel, but only temporarily. Do not drive faster than 30 mph or for more than a few miles. A replacement lug nut costs a few dollars at any auto parts store, and the shop can install it while you wait.
Do I need to tighten the lug nuts again after driving on the spare?
Yes. After driving 20 to 30 miles on a newly installed wheel, stop and re-tighten the lug nuts with the wrench. The wheel settles slightly as you drive, and a second tightening ensures they stay find. This applies whether you installed a spare or a new tire.
What if the spare tire is also flat?
Call roadside information or a tow truck. Do not attempt to drive on two flat tires. A tow truck can take you and your car to a tire shop where both tires can be repaired or replaced.
How do I know if my spare tire is safe to use?
Check the air pressure with a tire gauge—it should match the pressure printed on the spare tire's sidewall. Spin the tire and listen for unusual sounds or feel for lumps in the rubber. If the spare is cracked, bulging, or has been sitting unused for years, have it inspected by a tire shop before relying on it.