The TPMS light doesn't always mean a tire is flat

Your Honda's tire pressure monitoring system (TPMS) light turns on when the system detects that one or more tires are underinflated — but "underinflated" according to the sensor, not necessarily according to what you see. A tire can look normal and still trigger the light if its pressure has dropped below the threshold your Honda's computer is watching for. The light also turns on for reasons that have nothing to do with actual tire pressure: a faulty sensor, a sensor battery running out, or a sensor that got knocked loose during a tire rotation or repair.

The first step is always to check your actual tire pressures with a reliable gauge, because the light might be correct and you might not notice a slow leak by eye alone. After that, you'll need to figure out whether the problem is real pressure loss, a sensor issue, or something else entirely.

Key Takeaways

  • Check all four tire pressures with a gauge at a gas station or tire shop, because a tire can look fine and still be 5 to 10 pounds under the recommended pressure.
  • Your Honda's recommended tire pressure is printed on a sticker inside the driver's door jamb, not on the tire sidewall itself.
  • If all four tires are at the correct pressure and the light stays on, the problem is almost always a faulty TPMS sensor or a sensor battery that has died.
  • A single faulty sensor costs $150 to $300 to replace at a Honda dealer, and the light will not turn off until that sensor is replaced.
  • Tire shops and independent mechanics can often replace TPMS sensors for less than a dealer, but make sure they have the right sensor for your model year.

How to check your tire pressure correctly

Use a digital or dial tire gauge, not the stick gauges that come free at gas stations — those are notoriously inaccurate. You need the pressure when the tires are cold, meaning the car has been parked for at least three hours or driven less than a mile at low speed. Warm tires read 3 to 5 pounds higher than they actually are when cold, which can mask a real pressure problem.

Open the driver's door and look at the sticker on the inside of the door jamb. That sticker shows your Honda's recommended tire pressure — usually 32 to 35 PSI, depending on your model and year. Write down the number. Then check all four tires, including the spare if your Honda has a TPMS sensor in the spare (most do not, but some newer models do). If any tire is 2 or more pounds below the recommended pressure, inflate it to the correct number and check again the next morning to see if it lost pressure overnight.

If all four tires are at the correct pressure and the light is still on, the TPMS system itself has a problem, not your tires.

When the problem is a faulty sensor, not low pressure

Each wheel has a TPMS sensor mounted inside the tire rim. The sensor has a battery that lasts roughly 5 to 10 years. When the battery dies, the sensor stops sending a signal to your Honda's computer, and the computer turns on the TPMS light because it can no longer hear from that wheel. You'll see the light stay on constantly, not blink on and off.

A sensor can also fail if it gets damaged during a tire rotation, punctured by a tire repair, or corroded by road salt. If you recently had a tire service and the light came on right after, the sensor may have been knocked loose or damaged during the work. Call the shop that did the service and ask whether they touched the sensor.

The only way to know which sensor is faulty is to have a Honda dealer or tire shop scan the TPMS system with a diagnostic tool. The scan will tell you which wheel's sensor is not communicating. You cannot fix this by inflating the tire or checking the pressure — the sensor itself has to be replaced.

What a TPMS sensor replacement costs and where to get it

A Honda dealer will charge $150 to $300 per sensor, including the part and labor. Independent tire shops and mechanics often charge $100 to $200 per sensor. The price depends on your Honda's model year and whether the sensor is a direct sensor (mounted on the rim) or an indirect sensor (which uses your car's existing wheel speed sensors and does not require a new part on the wheel).

Most Hondas from 2008 onward use direct TPMS sensors. Older Hondas may use indirect systems. Before you pay for a replacement, ask the shop which type your car has and whether they have the correct sensor in stock for your specific model year. A sensor from a 2015 Honda Civic will not work in a 2020 Civic, even though both are Civics.

If you want to avoid the dealer, call two or three independent tire shops in your area and ask for a quote on a TPMS sensor replacement. Many shops can order the part and install it the same day or the next day. Make sure they can scan the system after installation to confirm the new sensor is communicating with your Honda's computer.

Slow leaks that don't show up visually

A tire can lose 5 to 10 pounds of pressure over several weeks without looking noticeably flat. This happens with slow leaks caused by a puncture too small to see, a valve stem that is not sealing properly, or a bead leak where the tire does not sit perfectly on the rim. Your TPMS sensor will catch this before you notice it by looking at the tire.

If your pressure check shows one tire is 2 to 5 pounds low and the others are fine, inflate that tire and watch it for the next few days. If it loses pressure again, you have a slow leak. Take the car to a tire shop and ask them to perform a pressure test. They will inflate the tire to the correct pressure, mark it with chalk, and check it again after 24 hours. If it has lost more than 2 pounds, they can find the leak by spraying soapy water on the tire to look for bubbles, or by submerging it in water.

A slow leak from a puncture can sometimes be patched for $15 to $30. A valve stem leak costs $20 to $50 to fix. A bead leak may require breaking the tire off the rim and reseating it, which costs $50 to $100. If the tire is old or damaged, the shop may recommend replacement instead.

What to do if the light came on after a tire service

If you had a tire rotation, repair, or replacement and the TPMS light came on within a day or two, call the shop that did the work. Ask them to rescan the TPMS system and check whether all four sensors are communicating. Sometimes a sensor gets bumped loose during a rotation and just needs to be reseated. Sometimes a sensor battery gets drained during the work and needs time to recover. Occasionally a sensor gets damaged and needs replacement.

Most reputable shops will rescan the system for free if the light came on right after their work. If they charged you for the service and the light is now on, they should stand behind their work. If the shop refuses to help, take the car to a Honda dealer or another tire shop for a diagnostic scan. The scan will show exactly which sensor is not working and whether it was damaged during the previous service.

Resetting the TPMS light after you fix the problem

Once you've replaced a faulty sensor or fixed a slow leak, the TPMS light should turn off on its own within a few minutes of driving. If it stays on after you've confirmed all tires are at the correct pressure and the new sensor has been installed, the system may need to be reprogrammed.

Some Honda models require you to hold down the TPMS reset button (usually located under the steering wheel or in the glove compartment) for a few seconds until the light blinks twice. Check your owner's manual for the exact location and procedure for your model year. Other Hondas reprogram automatically after you drive for a few miles at highway speed.

If the light still will not turn off after you've tried the reset procedure, take the car back to the shop that installed the new sensor and ask them to run another diagnostic scan. There may be a communication issue between the new sensor and your Honda's computer that requires reprogramming with a dealer-level tool.

Frequently Asked Questions

Can I drive with the TPMS light on?

Yes, you can drive safely as long as your tires are actually at the correct pressure. The light is a warning system, not a safety shutdown. However, if the light is on because one tire has a slow leak, that tire will continue to lose pressure and eventually become dangerously underinflated. Check your pressure and fix the underlying problem rather than ignoring the light.

Will the TPMS light turn off by itself?

No. If the light is on because a sensor battery has died or a sensor is faulty, the light will stay on until that sensor is replaced. If the light is on because of low pressure, it will turn off once the tire is inflated to the correct pressure and the sensor detects the change — usually within a few minutes of driving.

What's the difference between the TPMS light and the check engine light?

The TPMS light is shaped like a tire with an exclamation mark and indicates a tire pressure or sensor problem. The check engine light is a different symbol and indicates an engine, emissions, or transmission issue. Both can be on at the same time if your Honda has separate problems.

Can I replace a TPMS sensor myself?

Replacing the sensor itself requires breaking the tire off the rim, which needs a tire machine. You cannot do this at home. However, if you have tire machines and experience, you can buy the sensor online for $30 to $60 and install it yourself, then take the car to a shop to have the system scanned and reprogrammed.

Why did my TPMS light come on in winter?

Cold weather causes tire pressure to drop about 1 PSI for every 10 degrees Fahrenheit the temperature falls. If your tires were at 33 PSI in fall and the temperature dropped 30 degrees, they may now be at 30 PSI, which could trigger the TPMS light. Check your pressure and inflate if needed. This is normal and not a sign of a leak or sensor failure.