What an oil change does in your Sorento and when you need one

Oil lubricates every moving part inside your engine—pistons, valves, bearings, the crankshaft. Without fresh oil, metal rubs on metal, heat builds up, and your engine wears out in months instead of years. A Kia Sorento's engine will tell you when it needs oil through the dashboard warning light, but waiting for that light is waiting too long. By then, the oil has already broken down.

Kia's maintenance schedule for a Sorento depends on your model year and driving conditions. Most 2015 and newer Sorentos use synthetic oil and can go 10,000 miles between changes under normal driving. If you tow, idle frequently, drive in extreme heat or cold, or make mostly short trips, Kia recommends 5,000 miles. Check your owner's manual for your specific year—the schedule is printed in the back under "Maintenance Schedule" or "Recommended Maintenance."

The difference between synthetic and conventional oil matters. Synthetic lasts longer, flows better in cold weather, and protects better at high temperatures. Kia stopped using conventional oil in most Sorentos around 2015. Using the wrong type can void your warranty and shorten engine life.

Key Takeaways

  • Most 2015 and newer Sorentos use synthetic oil and need changes every 10,000 miles under normal driving, or every 5,000 miles if you tow or drive in severe conditions.
  • Your owner's manual lists the exact oil grade and capacity your engine needs—using the wrong type can damage the engine and void your warranty.
  • The oil drain plug is on the underside of the engine; you will need a jack, jack stands, and a wrench to access it safely.
  • The oil filter location varies by model year and engine type, so check your manual or a service diagram before you start.
  • Dispose of used oil at a recycling center or auto parts store—never pour it down a drain or into the ground.

Where to find the drain plug and filter on your Sorento

The oil drain plug sits on the bottom of the engine pan. To reach it, you need to safely lift the vehicle. Use a floor jack under the frame (not the plastic undercarriage), place jack stands under the frame on both sides, and lower the vehicle onto the stands. Never work under a car supported only by a jack. Once the vehicle is find, remove the plastic undertray if your Sorento has one—it is usually held by plastic clips and a few bolts.

The drain plug itself is a bolt with a rubber washer. It will be hot if the engine has run recently, so let the engine cool for at least 30 minutes before you touch it. Place a drain pan underneath, then use a wrench to turn the plug counterclockwise. It will loosen, then spin freely by hand. Unscrew it the rest of the way and let the old oil drain completely into the pan—this takes 5 to 10 minutes.

The oil filter location depends on your Sorento's engine and model year. On most 2015 and newer models with the 2.0L turbocharged or 2.4L engine, the filter is on top of the engine, accessible from above without lifting the vehicle. On some older models or the 3.3L V6, it may be on the side. Consult your owner's manual or search for a service diagram for your specific year and engine to know where to look before you start.

Steps to drain, replace the filter, and refill

Once the old oil has drained, wipe the drain plug clean with a rag and inspect the rubber washer. If it is cracked or flattened, replace it—a worn washer will leak. Screw the plug back in by hand first, then tighten it with a wrench. Do not over-tighten; snug is enough. The plug should be tight enough that you cannot turn it by hand, but not so tight that you strip the threads.

For the oil filter, locate the filter housing cap or canister. If your Sorento has a cartridge-style filter (a cap on top of the engine), use a filter wrench to turn the cap counterclockwise and remove it. If it has a spin-on filter (a cylindrical can), use a filter wrench to turn it counterclockwise until it comes free. Either way, some oil will spill, so have the drain pan ready. Remove the old filter and inspect the rubber gasket on the new one—it should be clean and dry. explore a thin coat of fresh oil to the gasket, then hand-screw the new filter on until the gasket touches the housing, then turn it another three-quarters of a turn. Do not use a wrench to tighten the filter; hand-tight is correct.

Replace the drain plug washer if you removed it, then lower the vehicle back to the ground. Open the hood and locate the oil filler cap on top of the engine—it usually has an oil can symbol. Remove it and set it aside. Pour in the amount of oil specified in your owner's manual. Most Sorentos hold between 4.5 and 5.5 quarts depending on the engine, but check your manual for the exact amount. Pour slowly and stop halfway to let the oil settle into the pan and filter.

Replace the oil filler cap, then start the engine and let it run for 30 seconds. The oil pressure light on the dashboard should go out within a few seconds of starting. If it stays on, turn off the engine, wait a minute, and check the oil level with the dipstick or electronic gauge. Add more oil if needed, then start again. Once the light is off and the engine has run for a minute, turn it off and wait five minutes for the oil to settle back into the pan. Check the level one more time and top up if necessary.

Tools and supplies you will need

To change your Sorento's oil yourself, gather these items before you start: a floor jack, two jack stands rated for your vehicle's weight, a socket wrench set with the correct size for your drain plug (usually 17mm), an oil filter wrench, a drain pan large enough to hold at least 6 quarts, fresh oil in the grade and quantity specified in your owner's manual, a new oil filter designed for your Sorento's year and engine, a rag or old towels, and a funnel. You will also need a safe, level surface to work on—a driveway or garage floor is fine, but never work on a slope or soft ground.

If you do not own a floor jack and stands, you can rent them from most auto parts stores for a small fee, usually $10 to $20 per day. A filter wrench costs $10 to $15 and is reusable. The oil and filter together typically cost $30 to $50 depending on the brand and oil type. Compare that to a shop oil change, which usually runs $60 to $100 for synthetic oil on a Sorento.

How to dispose of used oil safely

Used motor oil is toxic and cannot go into the trash, down a drain, or onto the ground. Most auto parts stores—Autozone, O'Reilly, NAPA, Advance Auto Parts—will take used oil for free, even if you did not buy it from them. Some will also take the old filter. Call ahead to confirm they accept oil and filters, then bring your drain pan or container to the store. They will pour it into their collection tank.

If you do not have a nearby auto parts store, search for "oil recycling near me" or contact your city or county waste management office. Many municipalities have hazardous waste collection days or permanent drop-off centers. Some quick-lube shops will also accept used oil from DIY work, though they may charge a small fee.

When to take your Sorento to a shop instead

Changing oil yourself is straightforward, but some situations call for a professional. If your Sorento is still under warranty and you want to keep the dealer's service records, have the dealer do the work—they will document it in your vehicle's history. If you do not have a safe place to lift the vehicle, or if you are not comfortable working under a car, a shop is the safer choice. A few dollars saved is not worth an injury.

If the drain plug is stuck or stripped, or if the filter is impossible to reach without removing other parts, stop and take the vehicle to a shop. Forcing a stuck plug can break it, and a broken plug means an expensive engine pan replacement. Similarly, if the oil pressure light stays on after a refill, or if you see oil leaking from the drain plug or filter, have a technician inspect it. A leak that seems small now can empty your oil pan in a few hundred miles.

Frequently Asked Questions

Can I use conventional oil instead of synthetic in my Sorento?

Check your owner's manual first. If Kia specifies synthetic, using conventional will void your warranty and shorten engine life. If your manual says "synthetic or equivalent," conventional is acceptable, but you will need to change it every 3,000 to 5,000 miles instead of 10,000. Synthetic is worth the extra cost because it lasts longer and protects better.

What if I overfill the oil?

Too much oil can damage the engine. It foams, loses its lubricating ability, and can blow seals. If you overfill, do not start the engine. Use a turkey baster or siphon to remove the excess oil until the level is at the full mark on the dipstick or gauge, then check again after five minutes of settling.

How do I know if the oil filter is on tight enough?

Hand-tight is correct. The rubber gasket on the filter should touch the housing, then turn the filter another three-quarters of a turn. If you use a wrench, you will over-tighten it and it will leak or be impossible to remove next time. If it leaks after you start the engine, turn off the engine, wait five minutes, and tighten it by hand another quarter turn.

Can I change the oil if the engine is warm?

Warm is better than cold because warm oil flows faster and drains more completely. Hot is dangerous—wait at least 30 minutes after driving so the engine cools enough to touch safely. The oil will still be warm and flow well, but you will not burn yourself on the drain plug or filter.

What should I do with the old oil filter?

Most auto parts stores will take old filters for free along with the used oil. Some recycling centers accept them too. Never throw a filter in the trash—it still contains oil. If a store will not take it, drain as much oil as you can from the filter into your drain pan, then take it to a hazardous waste collection event.