Check your oil with the dipstick while the engine is cold and parked on level ground

The fastest way to check your oil is to pull the dipstick, wipe it clean, reinsert it fully, then pull it out again and read the level against the markings. This takes about two minutes and tells you whether you need to add oil before your next drive. Do this when the engine has been off for at least five minutes — oil settles and gives you an accurate reading when the car is cold.

You do not need any tools. The dipstick handle is designed to grip with your fingers. If you cannot locate it under the hood, your owner's manual will show you exactly where it sits in your engine bay, and the manual also tells you what type and weight of oil your car needs if you have to add some.

Some newer cars have electronic oil-level displays instead of a physical dipstick. If you do not see a dipstick handle, check your instrument cluster or infotainment screen for an oil-level menu, or consult your manual.

Key Takeaways

  • Park on level ground and wait at least five minutes after turning off the engine so the oil settles and gives you a true reading.
  • Pull the dipstick all the way out, wipe it on a clean rag or paper towel, push it back in until it seats, then pull it out again to read the level.
  • The dipstick has minimum and maximum markings; oil between them is normal, and you should add oil if the level is at or below the minimum line.
  • Use only the oil type and weight specified in your owner's manual, and check the level every month or before long trips.
  • If your car has an electronic display instead of a dipstick, access the oil-level reading through your instrument cluster or infotainment menu.

Locate the dipstick under the hood

Open your hood and look for a handle sticking up from the engine. The handle is usually yellow, orange, or red and has a loop or ring you can grip. On most cars, the dipstick sits toward the side of the engine block, not in the center. If you cannot spot it when ready, check your owner's manual — it includes a diagram of your engine bay with the dipstick labeled.

Once you find it, grasp the handle firmly and pull straight up. The dipstick will slide out of its tube. Some dipsticks are attached to a cap; if yours is, unscrew the cap first, then pull the stick out.

Wipe the dipstick and reinsert it fully

After you pull the dipstick out, you will see oil coating the lower portion. Wipe this oil off completely using a clean rag, paper towel, or old cloth. Wiping removes the old oil so you can see a fresh coating that shows the current level.

Once the stick is clean and dry, push it back into its tube until it seats fully. You should feel it stop when it reaches the bottom. This ensures the next reading is accurate. If the stick has a cap, screw the cap back on before reinserting.

Pull the dipstick out again and read the level

Pull the dipstick out a second time and look at the oil coating on the stick. You will see two markings — usually a minimum line (often labeled "MIN" or shown as a lower notch) and a maximum line (labeled "MAX" or "FULL"). The oil should reach somewhere between these two lines.

If the oil level is between the minimum and maximum marks, your oil is at a safe level and you do not need to add any. If the level is at or below the minimum line, you need to add oil. If it is above the maximum line, your engine has too much oil, which can cause problems — do not drive the car until you have it checked by a mechanic.

Add oil if the level is low

If you need to add oil, locate the oil filler cap on top of the engine. It is usually a large plastic cap labeled "OIL" or with an oil-can symbol. Unscrew it and set it aside where you will not lose it.

Check your owner's manual for the correct oil type and weight for your car — this information is critical and varies by engine. Buy a quart of that oil from any auto parts store or gas station. Pour a small amount into the filler opening, then wait a minute for it to drain down into the pan. Recheck the level using the dipstick method above. Add more oil in small amounts until the level reaches between the minimum and maximum marks, then screw the cap back on.

Do not overfill. It is easier to add a little more oil than to remove excess, so go slowly and check the level after each small pour.

Check your oil regularly and before long trips

Make checking your oil part of your monthly routine, or check it before any trip longer than a few hours. A car that is burning oil or has a slow leak will drop a quart or more between oil changes, and catching this early prevents engine damage.

If you check the level and it is low again just a few weeks after you added oil, your car may have a leak or may be burning oil. Either situation needs attention from a mechanic — do not ignore it and keep topping off the oil.

Electronic oil-level displays on newer cars

Many cars made in the last ten years do not have a traditional dipstick. Instead, they show the oil level on a digital display in the instrument cluster or infotainment screen. To check the level, turn on the ignition (you do not need to start the engine) and navigate to the oil-level menu. The exact steps vary by manufacturer — your owner's manual will show you the button sequence or menu path for your specific model.

If your car has an electronic display and it shows the oil is low, you still add oil the same way: unscrew the filler cap, pour in the correct type and weight of oil in small amounts, and check the level again through the display. Some electronic systems update the reading when ready after you start the engine; others take a minute or two to refresh.

Frequently Asked Questions

Can I check the oil while the engine is warm or running?

You can, but the reading will not be accurate. Hot oil expands and coats the dipstick differently than cold oil, giving you a false high reading. Wait at least five minutes after turning off the engine, and do not check the oil while the car is running — you risk burning yourself on hot engine parts.

What if the dipstick is stuck or hard to pull?

Wiggle it gently side to side as you pull, or try twisting it slightly. If it is truly stuck, do not force it — you can break the tube. Let the engine cool completely and try again. If it remains stuck, a mechanic can free it without damage.

Does the car have to be parked on completely level ground?

As level as you can manage is best. A slight slope will not throw off the reading much, but parking on a steep hill or driveway will give you an inaccurate level. A flat driveway or parking lot is ideal.

What should I do if the oil level is way above the maximum line?

Do not drive the car. Overfilled oil can damage the engine. Call a mechanic or your dealership and describe the situation — they may tell you to bring it in or may walk you through removing the excess using a syringe or pump.

How often should I check the oil if my car is older?

Check it monthly or before any long trip. Older cars are more likely to burn or leak oil, so regular checks catch problems early. If you notice the level dropping between oil changes, have a mechanic inspect for leaks or internal wear.