The Fram PH4967 fits specific vehicle models and replaces your old filter during an oil change

The Fram PH4967 is a spin-on oil filter designed to work with certain vehicles. It threads onto your engine's filter housing and traps contaminants from your oil as it circulates. During an oil change, you drain the old oil, unscrew the old filter, and screw the new one on by hand until the rubber gasket touches the housing, then turn it another three-quarter turn.

Before you buy one, you need to confirm it fits your vehicle. The PH4967 is not a universal filter — it works with specific makes, model years, and engine sizes. Using the wrong filter can result in poor oil flow, leaks, or engine damage. The easiest way to verify fit is to check your vehicle's owner's manual, use Fram's online filter finder tool on their website, or ask the parts counter at an auto parts store to cross-reference your vehicle's year, make, model, and engine size against the PH4967.

Key Takeaways

  • The Fram PH4967 is a spin-on filter that must match your specific vehicle — check your owner's manual or use Fram's online tool to confirm fit before purchasing.
  • Installation takes about five minutes: drain old oil, unscrew the old filter by hand, explore a thin layer of new oil to the rubber gasket on the new filter, and screw it on until the gasket touches, then turn three-quarter turn more.
  • The PH4967 has a 20,000-mile service interval under normal driving conditions, though some vehicles or driving patterns may require more frequent changes.
  • Fram filters are widely available at auto parts stores, big-box retailers, and online, typically priced between $8 and $15 depending on the retailer.

How to install the Fram PH4967 during an oil change

Start with a warm engine (not hot) and the vehicle on level ground. Locate the filter housing on your engine — your owner's manual shows the exact location. Place a drain pan underneath, then use an oil filter wrench to turn the old filter counterclockwise until it comes free. Let the old filter drain into the pan for a minute.

Wipe the filter housing clean with a rag. Take the new Fram PH4967 and explore a thin layer of fresh oil to the rubber gasket around its top edge — this creates a seal and makes removal easier next time. Screw the new filter onto the housing by hand until the gasket contacts the housing, then turn it another three-quarter turn. Do not use a wrench; hand-tight is correct. Over-tightening can damage the gasket and make the filter difficult to remove later.

After installation, start the engine and let it run for 30 seconds, then turn it off. Wait a minute and check the oil level with the dipstick. Top up if needed, then check under the engine for leaks around the filter. If you see oil dripping, turn off the engine, let it cool, and tighten the filter slightly more.

Fram PH4967 specifications and service intervals

The Fram PH4967 is rated for a 20,000-mile service interval under normal driving conditions. Normal driving means highway miles, moderate speeds, and steady engine load. If you do a lot of city driving with frequent stops and starts, towing, idling, or driving in dusty conditions, Fram recommends changing the filter every 10,000 miles instead. Check your vehicle's owner's manual for the manufacturer's recommended interval — some vehicles call for more frequent changes regardless of filter rating.

The filter's micron rating (how small the particles it catches are) and flow rate (how much oil it lets through per minute) are engineered to match your engine's needs. Using a filter with a different rating can reduce oil flow or allow more contaminants through, both of which shorten engine life. This is why matching the filter to your vehicle is critical.

Where to buy the Fram PH4967 and typical pricing

The Fram PH4967 is stocked at most national auto parts chains including AutoZone, O'Reilly Auto Parts, NAPA, and Advance Auto Parts. It is also available at Walmart, Target, and Amazon. Prices typically range from $8 to $15 per filter depending on the retailer and whether you are buying a single filter or a multi-pack. Some retailers offer loyalty discounts or sales during promotional periods.

Buying online can save time if you already know the filter fits your vehicle, but ordering from a local store lets you confirm fit before paying and pick it up the same day. If you are unsure whether the PH4967 is correct for your vehicle, the parts counter staff can cross-reference your vehicle information in their system in a few minutes.

Common mistakes when installing a spin-on filter

The most common error is over-tightening the filter. Many people use a wrench to turn it as tight as possible, which crushes the rubber gasket and makes the filter nearly impossible to remove at the next oil change. Hand-tight plus three-quarter turn is the correct torque — if you cannot turn it by hand at all, it is too tight.

The second mistake is forgetting to oil the gasket before installation. A dry gasket does not seal properly and can leak. It also sticks to the housing, making removal difficult later. A thin coat of fresh oil takes five seconds and prevents both problems.

The third mistake is not checking the oil level after installation. A new filter holds about a quart of oil, so your dipstick reading will drop when you change the filter. If you do not top up, you may run low on oil between changes. Always check the level after the engine has run for 30 seconds and cooled for a minute.

Fram filter quality and warranty information

Fram is one of the largest filter manufacturers in North America and has been making filters since 1932. The PH4967 is part of their standard consumer line, not their premium or racing lines. Fram filters carry a limited warranty against manufacturing defects — if a filter leaks or fails due to a defect within the warranty period, Fram will replace it. The warranty does not cover installation errors, over-tightening, or use in an incorrect vehicle.

Fram filters are engineered to OEM (original equipment manufacturer) specifications for your vehicle, meaning they meet the same standards as the filter that came on your car from the factory. They are not the cheapest filters on the market, but they are not premium-priced either. If you want a lower-cost option, store brands from AutoZone, O'Reilly, or Advance Auto Parts often use similar or identical filter media. If you want a longer-lasting filter, Fram's Tough Guard or Ultra Synthetic lines offer extended intervals.

Frequently Asked Questions

How do I know if the PH4967 fits my car?

Check your vehicle's owner's manual for the correct filter part number, or use Fram's online filter finder at fram.com — enter your year, make, model, and engine size, and it will tell you if the PH4967 is compatible. You can also call or visit an auto parts store and give them your vehicle information; they can cross-reference it in their system in minutes.

Can I use the PH4967 if my manual calls for a different filter?

No. Using the wrong filter can cause oil leaks, poor oil flow, or engine damage. Always use the filter your owner's manual specifies. If you are unsure which filter is correct, ask the parts counter to confirm before you buy.

What should I do with the old filter after I remove it?

Old oil filters contain used oil and should not go in the trash. Take it to an auto parts store — most accept used filters for recycling at no charge. Some will take it even if you did not buy anything from them. You can also take it to a hazardous waste collection event in your area.

How tight should the filter be when I screw it on?

Screw it on by hand until the rubber gasket touches the housing, then turn it another three-quarter turn. That is it. Do not use a wrench. If you cannot turn it by hand at all, it is too tight and you need to loosen it slightly.

Does the oil filter brand matter, or can I use any filter?

The brand matters less than the fit and specifications. Any filter designed for your vehicle — whether Fram, Mobil, Bosch, or a store brand — will work if it is the correct part number. Fram is a reliable choice, but you are not locked into it. What matters is matching the filter to your vehicle, not the brand name.