The 6.7 Powerstroke crankcase filter is a separate maintenance item from your oil filter, and it catches blow-by gases before they re-enter the engine

The crankcase filter on a 6.7 Powerstroke diesel sits on top of the valve cover and filters air that comes back into the crankcase from the positive crankcase ventilation (PCV) system. It is not the same as your engine oil filter. While your oil filter removes particles from the oil itself, the crankcase filter removes moisture and contaminants from gases that escape past the piston rings during combustion — a normal process called blow-by.

On the 6.7 Powerstroke, this filter is a cylindrical cartridge that you replace during regular maintenance intervals. Neglecting it can lead to moisture buildup in the crankcase, which thickens oil, reduces lubrication, and can eventually cause sludge formation. The filter is inexpensive to replace and takes only a few minutes, making it one of the easiest preventive maintenance tasks you can do.

Key Takeaways

  • The crankcase filter removes moisture and contaminants from blow-by gases, not from the oil itself, so it works alongside your oil filter rather than replacing it.
  • Ford recommends replacing the 6.7 Powerstroke crankcase filter every 10,000 miles or annually, whichever comes first, though some owners extend this interval based on driving conditions.
  • The filter cartridge costs between $15 and $35 depending on the brand, and you can replace it yourself with basic hand tools in under ten minutes.
  • A clogged or missing crankcase filter allows moisture to accumulate in the crankcase, which can lead to oil sludge and accelerated engine wear.

Where the crankcase filter sits and what it does

The crankcase filter on a 6.7 Powerstroke is mounted on top of the driver's side valve cover. It looks like a short cylindrical cartridge, roughly three inches tall and two inches in diameter. The filter connects to the PCV system, which is designed to route blow-by gases back into the intake manifold rather than venting them to the atmosphere — this reduces emissions and recycles unburned fuel.

Without the crankcase filter, those gases would carry moisture and oil mist directly into the crankcase. Over time, this moisture condenses and mixes with the oil, creating an emulsion that looks like a milky sludge on the dipstick or inside the oil cap. The filter cartridge traps this moisture and particulate matter, keeping the crankcase oil cleaner and drier.

Replacement interval and when to change it

Ford's service schedule for the 6.7 Powerstroke calls for crankcase filter replacement every 10,000 miles or once per year, whichever comes first. If you drive in severe conditions — towing frequently, idling for long periods, or operating in dusty environments — you may want to replace it more often, as blow-by increases under load and the filter will clog faster.

Some owners who drive primarily on highways and maintain consistent engine temperatures stretch the interval to 15,000 miles without issues. However, the low cost of the filter and the ease of replacement make it sensible to follow Ford's recommendation, especially if you tow or operate in dusty conditions. Checking the filter visually during oil changes is a good habit — if it looks dark or clogged, replace it regardless of mileage.

How to replace the 6.7 Powerstroke crankcase filter yourself

Replacing the crankcase filter requires only a socket wrench or adjustable wrench and takes about five minutes. The filter cartridge is held in place by a single bolt at the top. Locate the filter on the driver's side valve cover, remove the bolt, and pull the cartridge straight up and out. The rubber seal will come with it.

Before installing the new filter, wipe the sealing surface on the valve cover with a clean rag to remove any oil residue or debris. Install the new cartridge with a fresh rubber seal (most replacement filters come with one), hand-tighten the bolt, and then snug it with your wrench — do not over-tighten, as the seal is rubber and can be damaged. Start the engine and check for leaks around the base of the filter. If none appear after a minute, you are done.

Cost and parts availability

OEM Ford crankcase filters for the 6.7 Powerstroke typically cost between $20 and $35, depending on where you purchase them. Aftermarket options from brands like Motorcraft, Fram, and Baldwin range from $15 to $30. The filter is widely available at Ford dealerships, auto parts chains, and online retailers, so sourcing one is not difficult.

If you have the filter replaced at a dealership as part of a scheduled service, expect to pay $50 to $100 in labor on top of the parts cost. Independent diesel shops usually charge $30 to $60 for the replacement. Given the simplicity of the job, many owners do this themselves and save the labor cost entirely.

Signs of a clogged or failing crankcase filter

A clogged crankcase filter will not cause an obvious warning light, but you may notice subtle signs of trouble. If you see a milky or foamy appearance on the dipstick or inside the oil filler cap, moisture is accumulating in the crankcase — often a sign that the filter is not doing its job. You might also notice slightly higher oil pressure readings on the gauge, as thickened oil from moisture buildup resists flow.

In some cases, a severely clogged filter can cause slight pressure buildup in the crankcase, which may force oil past gaskets or seals. This is rare but can result in small oil leaks around the valve cover gasket or other sealing points. If you notice any of these signs, replace the crankcase filter when ready and check the oil condition — if it looks milky, consider an oil change as well to remove the contaminated fluid.

Crankcase filter versus oil filter: what is the difference

The crankcase filter and the oil filter serve different purposes and should not be confused. The oil filter removes particles from the circulating engine oil — dirt, metal shavings, and combustion byproducts. The crankcase filter removes moisture and contaminants from the gases that escape the combustion chamber. You need both, and they work independently of each other.

On a 6.7 Powerstroke, the oil filter is a spin-on cartridge located on the side of the engine block, and it is replaced every 7,500 to 10,000 miles depending on your driving conditions and the oil type you use. The crankcase filter sits on the valve cover and is replaced on a similar schedule. Replacing one does not affect the other, so treat them as separate maintenance items.

Frequently Asked Questions

Can I drive without a crankcase filter?

Technically yes, but you should not. Without the filter, moisture and oil mist from blow-by will accumulate in the crankcase, leading to sludge formation and accelerated engine wear. Some owners have removed the filter to reduce intake restriction, but this practice shortens engine life and is not recommended.

What happens if the crankcase filter is clogged?

A clogged filter restricts the flow of blow-by gases back into the intake, which can increase crankcase pressure and force oil past gaskets and seals. You may see small oil leaks or notice milky oil on the dipstick as moisture builds up. Replacing the filter resolves the issue.

Is the crankcase filter the same as the PCV valve?

No. The PCV valve is a separate component that regulates the flow of blow-by gases back into the intake manifold. The crankcase filter cleans those gases before they reach the PCV valve. Both are part of the same system but serve different functions.

Do I need to replace the rubber seal when I change the crankcase filter?

Most replacement filters come with a new rubber seal included. If yours does not, purchase a seal separately — they cost a few dollars. Always use a fresh seal rather than reusing the old one, as the rubber hardens over time and may not seal properly.

How do I know if my crankcase filter needs replacing before the scheduled interval?

Inspect the filter visually during oil changes. If it appears dark, clogged, or wet with oil, replace it. You can also check the oil on the dipstick — if it looks milky or foamy, the crankcase filter may be failing and moisture is building up in the oil.