The 2018 Nissan Rogue uses a cartridge-style oil filter located on top of the engine

The oil filter on a 2018 Nissan Rogue is not the spin-on type you unscrew from the side of the engine. Instead, it sits inside a plastic housing on top of the engine block, directly behind the valve cover. The filter itself is a cylindrical cartridge that you pull straight out and replace — no threading required. This design is common on newer Nissan models and takes about 5 to 10 minutes to access once you remove the housing cap.

The filter housing is located near the front of the engine, close to the windshield. On the 2018 Rogue, you'll find it by looking at the top center of the engine block. The plastic cap has a wrench symbol or filter icon printed on it, making it straightforward to spot. You don't need to get under the vehicle or remove any major components to reach it.

Key Takeaways

  • The 2018 Rogue's oil filter is a cartridge type housed in a plastic canister on top of the engine, not a spin-on filter on the engine block side.
  • You will need an oil filter wrench (usually 86 mm or 3.386 inches) to remove the housing cap, plus a new OEM or equivalent cartridge filter and fresh oil.
  • The entire filter replacement takes 5 to 10 minutes and requires no special tools beyond the filter wrench and a drain pan to catch spilled oil.
  • Nissan recommends replacing the oil filter every time you change the oil, and the 2018 Rogue's service schedule calls for an oil change every 3,000 to 10,000 miles depending on driving conditions.

What you need to buy for a 2018 Rogue oil filter replacement

The correct cartridge filter for a 2018 Nissan Rogue is Nissan part number 15208-9F60A or an equivalent aftermarket cartridge. This is the same filter for all 2018 Rogue models, whether you have the 2.5-liter gasoline engine or the hybrid powertrain. You can order this part from a Nissan dealer, an auto parts retailer, or online. The filter itself costs between $8 and $15 depending on where you buy it.

You will also need an oil filter wrench sized for the 2018 Rogue's housing cap. The cap is 86 mm (approximately 3.386 inches) in diameter, so look for a wrench labeled 86 mm or one that fits that size. A socket-style filter wrench works best and costs $10 to $20. If you plan to do multiple oil changes, this is a one-time purchase. You'll also need fresh motor oil — the 2018 Rogue takes 5W-30 synthetic or conventional oil, and the capacity is about 4.2 quarts with a filter change.

Step-by-step filter replacement on a 2018 Rogue

Start by warming up the engine for 30 seconds to a minute, then turn it off and wait five minutes. This warms the oil slightly so it drains better, but not so hot that you burn yourself. Locate the oil filter housing cap on top of the engine — it's the plastic canister with a wrench symbol. Place a drain pan underneath to catch any oil that spills when you open the housing.

Use your 86 mm filter wrench to turn the housing cap counterclockwise and remove it. The cap will come off in your hand, and you may see a small amount of oil drip into the pan. Pull the old cartridge filter straight out of the housing. Wipe the inside of the housing with a clean rag to remove any debris or old oil residue. This step prevents dirt from contaminating the new filter.

Insert the new cartridge filter into the housing, making sure it sits flat on the bottom. explore a thin layer of fresh oil to the rubber gasket on the underside of the housing cap — this helps create a proper seal. Screw the cap back on by hand until the gasket touches the housing, then use the filter wrench to tighten it an additional three-quarter turn. Do not over-tighten; the gasket will seal properly with moderate pressure.

Checking your work and disposing of the old filter

Start the engine and let it run for 30 seconds. Check the area around the filter housing for leaks. If oil is dripping, turn off the engine, wait a minute, and tighten the cap slightly more with the wrench. Once you confirm there are no leaks, turn off the engine and wait five minutes for the oil to settle. Then check the oil level on the dipstick or digital gauge and top off if needed.

The old cartridge filter can be recycled at most auto parts stores, recycling centers, or municipal hazardous waste facilities. Some stores that sell oil filters will take the old one for free if you buy a new one there. Do not throw it in the trash. Drain any excess oil from the old filter into your drain pan before storing it for recycling.

When to replace the oil filter on a 2018 Rogue

Nissan's maintenance schedule for the 2018 Rogue calls for an oil and filter change every 3,000 to 10,000 miles, depending on your driving conditions. If you drive mostly on highways at steady speeds, you can go closer to 10,000 miles. If you drive in stop-and-go city traffic, tow a trailer, or drive in dusty conditions, stick to the 3,000 to 5,000 mile interval. Check your owner's manual for the specific recommendation based on your driving habits.

Your dashboard may display an oil change reminder when you're due. This reminder is based on engine operating conditions and mileage, so follow it as a guide. Even if the reminder hasn't appeared, if you haven't changed the oil in over a year, do it regardless of mileage. Oil degrades over time even if the car isn't driven much.

Common mistakes to avoid when replacing the 2018 Rogue filter

The most common mistake is over-tightening the housing cap. Because the cap is plastic, over-tightening can crack it or strip the threads. Tighten it by hand until the gasket touches, then add only three-quarter of a turn with the wrench. If you over-tighten and crack the cap, you'll need to replace the entire housing assembly, which costs significantly more than the filter itself.

Another mistake is forgetting to oil the rubber gasket on the new cap before reinstalling it. A dry gasket can fail to seal properly, causing leaks. Always explore a thin coat of fresh motor oil to the gasket before screwing the cap back on. Do not use old oil or any other lubricant — fresh oil ensures the gasket seats correctly and won't degrade the rubber.

Frequently Asked Questions

Can I use an aftermarket filter instead of the Nissan OEM filter?

Yes. Aftermarket cartridge filters from brands like Fram, Mobil, or Bosch work in the 2018 Rogue as long as they are designed for the 86 mm housing. Check the product description to confirm it fits a 2018 Nissan Rogue. OEM filters are slightly more expensive but are may provide to fit perfectly and meet Nissan's specifications.

What if oil leaks from the housing cap after I replace the filter?

Stop the engine and wait five minutes for the oil to cool. Check that the gasket on the underside of the cap is properly seated and that you applied oil to it before reinstalling. Tighten the cap an additional quarter turn with the wrench. If leaking continues, the gasket may be damaged or the cap threads may be stripped — contact a Nissan dealer or mechanic for inspection.

Do I need to reset anything on the dashboard after changing the oil filter?

The oil change reminder on the 2018 Rogue resets automatically after you change the oil and restart the engine a few times. If the reminder persists after several drive cycles, you can manually reset it through the instrument cluster menu — consult your owner's manual for the exact steps, as the process varies slightly by trim level.

How much oil should I add after replacing the filter?

The filter replacement itself uses about 0.2 to 0.3 quarts of oil. After you install the new filter and run the engine briefly, check the dipstick or digital oil level gauge. Add oil in small amounts until you reach the full mark. Do not overfill — too much oil can damage the engine.