The right oil filter for your 2017 Tacoma depends on which engine you have
The 2017 Toyota Tacoma came with two engine options: a 2.7-liter four-cylinder or a 3.5-liter V6. Each uses a different oil filter. The four-cylinder takes a Toyota part number 90915-YFZF9, while the V6 uses 90915-YFZF8. You can find your engine size on the vehicle information label inside the driver's door jamb, or check your owner's manual.
Both filters are spin-on cartridge filters that screw directly onto the engine block. They cost between $8 and $15 at most auto parts stores, and Toyota dealerships stock both. If you're buying a replacement filter without knowing which engine you have, bring your VIN to the parts counter — they can look it up in seconds.
Key Takeaways
- The 2017 Tacoma four-cylinder uses Toyota filter 90915-YFZF9, and the V6 uses 90915-YFZF8.
- You can confirm your engine size from the door jamb label or your owner's manual before buying.
- Both filters are standard spin-on types that cost $8 to $15 and are widely available at auto parts retailers.
- Aftermarket filters from Fram, Mobil 1, and Bosch are compatible with both engines if you prefer a different brand.
How to identify which filter your truck needs
The easiest way is to look at the vehicle information label on the inside of your driver's door. Open the door and look at the jamb — you'll see a sticker with engine displacement listed. It will say either 2.7L or 3.5L. Write that down before you go to the parts store.
If the label is worn or missing, your owner's manual lists the engine size in the specifications section near the front. You can also call a Toyota dealership with your VIN and ask which engine your truck has — they'll tell you over the phone without charging you.
OEM versus aftermarket filters for the 2017 Tacoma
Toyota's original equipment filters (90915-YFZF9 and 90915-YFZF8) are reliable and widely stocked. They typically cost $10 to $15 and come with the crush washer already installed, which makes installation straightforward.
Aftermarket filters from Fram, Mobil 1, Bosch, and Wix all fit the 2017 Tacoma and meet the same performance standards. Many truck owners choose aftermarket filters because they're often cheaper or come with extended warranties. When you buy an aftermarket filter, check the packaging to confirm it lists the 2017 Tacoma as compatible — the part number will be different from Toyota's, but the thread size and mounting are the same.
What to check before you install a new filter
Before you screw on a new filter, make sure the old filter's rubber gasket came off with it. If the gasket stayed stuck to the engine block, you'll see a thin rubber ring around the mounting surface. Wipe it off with a clean rag — installing a new filter over an old gasket will cause an oil leak.
When you install the new filter, hand-tighten it until the rubber gasket touches the block, then turn it another three-quarters of a turn. Do not use a wrench — over-tightening crushes the gasket and makes the filter hard to remove next time. The filter should be snug but not locked down.
Where to buy filters for your 2017 Tacoma
Auto parts chains like AutoZone, O'Reilly, NAPA, and Advance Auto Parts stock both Toyota OEM filters and multiple aftermarket brands. You can order online and pick up the same day, or buy in person. Walmart and Costco carry filters too, though selection is usually smaller.
Toyota dealerships have the OEM filters in stock and can order them if they're temporarily out. Dealership filters cost more than retail chains but come with the assurance that they're genuine Toyota parts. Online retailers like Amazon stock both OEM and aftermarket options, though shipping times vary.
Oil filter change intervals for the 2017 Tacoma
Toyota recommends changing the oil and filter every 10,000 miles or 12 months, whichever comes first. If you use synthetic oil, the interval extends to 10,000 miles or 12 months as well — Toyota does not extend synthetic intervals for the Tacoma the way some manufacturers do. Check your owner's manual for the exact recommendation for your truck.
If you drive in severe conditions — towing, dusty terrain, or frequent short trips — Toyota suggests changing the filter every 5,000 miles. Keep your maintenance records in case you sell the truck; buyers often ask for proof of regular service.
Frequently Asked Questions
Can I use the V6 filter on my four-cylinder Tacoma?
No. The filters have different thread sizes and mounting configurations. Using the wrong filter will either not fit or will leak. Always confirm your engine size before buying.
Do I need to replace the crush washer every time I change the filter?
Yes. The crush washer is a small rubber ring that seals the filter to the block. It compresses when you tighten the filter and cannot be reused. Most new filters come with a washer already installed, but check the packaging to be sure.
What happens if I don't change the filter at the recommended interval?
A clogged filter restricts oil flow to the engine, which can cause low oil pressure and engine damage over time. The filter's job is to trap metal particles and debris; once it's full, it stops working effectively. Stick to the 10,000-mile interval to keep your engine clean.
Is there a difference between Toyota filters and Fram or Mobil 1 filters?
All filters sold for the 2017 Tacoma meet the same performance and pressure standards. Toyota filters are OEM parts made to Toyota's specifications, while aftermarket filters are made by other manufacturers to fit the same process. Both work well; the choice usually comes down to price and availability.