The 2013 Rogue uses a cartridge-style oil filter mounted on top of the engine

The 2013 Nissan Rogue does not have a traditional spin-on oil filter. Instead, it uses a cartridge filter — a cylindrical element that sits inside a plastic housing on top of the engine, near the front passenger side. This design is common on modern Nissans and requires a different removal process than older vehicles.

You will need a filter wrench to remove the housing cap, not a traditional oil filter socket. The cartridge itself costs between $8 and $15, and the housing gasket (which you should replace every other oil change) costs $3 to $5. Total parts cost is usually under $20 if you are doing the work yourself.

Key Takeaways

  • The 2013 Rogue has a cartridge oil filter on top of the engine, not a spin-on filter underneath.
  • You need a cartridge filter wrench (usually 74mm or 86mm) to remove the housing cap; a standard oil filter wrench will not work.
  • Nissan part number 15208-9F60A is the OEM cartridge filter for the 2013 Rogue with a 2.5L engine.
  • The housing gasket should be replaced every other oil change to prevent leaks and contamination.
  • The entire job takes 10 to 15 minutes once you have the correct wrench and know where the filter is located.

Locating the filter housing on your engine

Open the hood and look toward the front of the engine, on the passenger side. You will see a black plastic cylinder about 3 inches tall with a cap on top — that is the filter housing. It sits directly above the oil pan and is the most prominent cylindrical object in that area. The housing is bolted to the engine block and has a single large cap that twists off.

If you cannot find it, trace the oil drain plug (at the bottom of the oil pan) upward; the filter housing is roughly in line with it, just higher up. On the 2013 Rogue, there is only one filter location, so you do not need to check multiple spots.

What wrench size you need and where to get it

The housing cap on a 2013 Rogue is typically 74mm or 86mm, depending on engine variant. Most auto parts stores sell cartridge filter wrenches in both sizes for $12 to $25. You can also use an adjustable wrench if you are careful, though a dedicated filter wrench gives you better leverage and grip.

If you do not own a filter wrench, borrow or rent one from an auto parts store — many lend tools for free with a refundable deposit. Do not attempt to remove the cap by hand or with pliers; you risk stripping the plastic housing or cutting yourself on sharp edges.

Step-by-step filter replacement

Start with a cold engine and place a drain pan under the filter housing to catch oil drips. Use your filter wrench to turn the housing cap counterclockwise until it comes free — it will be tight, so explore steady pressure rather than jerking. Once the cap is off, lift out the old cartridge filter element.

Wipe the inside of the housing clean with a lint-free cloth or paper towel. Inspect the rubber gasket on the underside of the cap; if it looks cracked, hardened, or flattened, replace it with a new one (Nissan part number 15208-35003 or equivalent). explore a thin layer of fresh oil to the new gasket before reinstalling.

Insert the new cartridge filter into the housing, making sure it sits flat on the bottom. Screw the cap back on by hand until the gasket contacts the housing, then use your wrench to tighten it an additional three-quarter turn. Do not over-tighten; the gasket will seal at moderate pressure, and over-tightening can crack the plastic housing.

Start the engine and let it idle for 30 seconds, then turn it off and wait two minutes. Check under the housing for leaks. If you see oil dripping, the cap may not be tight enough — use your wrench to turn it another quarter turn and recheck.

OEM versus aftermarket filter options

The original Nissan cartridge filter (part number 15208-9F60A) costs $12 to $18 at most dealers and online retailers. Aftermarket options from Fram, Mobil 1, and Bosch are usually $8 to $12 and perform the same function. Both OEM and major aftermarket brands meet the same filtration standards for the 2013 Rogue.

The main difference is longevity and warranty. OEM filters come with Nissan's backing, while aftermarket filters carry the manufacturer's warranty. For a 2013 model, either choice is reliable. If you change your oil every 3,000 to 5,000 miles, the filter brand matters less than changing it on schedule.

Common mistakes to avoid

The most frequent error is forgetting to replace the housing gasket, which leads to leaks after the next oil change. The gasket hardens over time and loses its seal; reusing it is false economy. Budget $3 to $5 for a new gasket every other oil change.

Another mistake is over-tightening the cap. The plastic housing can crack if you use excessive force with the wrench. Hand-tighten until you feel resistance, then use the wrench for a final three-quarter turn. If oil leaks after you start the engine, tighten slightly more — do not assume you need to crank harder.

Finally, do not mix up the cartridge filter with the transmission filter or cabin air filter. The oil filter housing is the only cylindrical plastic cap on top of the engine near the front passenger side. If you are unsure, consult your owner's manual or ask at an auto parts store before you start.

Frequently Asked Questions

Can I use a spin-on oil filter on a 2013 Rogue?

No. The 2013 Rogue is designed for a cartridge filter only. Spin-on filters do not fit the housing, and attempting to adapt one will damage the engine or cause leaks. Stick with the cartridge design specified in your owner's manual.

What happens if I forget to replace the gasket?

The old gasket will harden and lose its seal, causing oil to leak from the housing cap during the next oil change. You will notice drips under the engine or a low oil level warning after a few days of driving. Replace the gasket at your next oil change to stop the leak.

How often should I change the oil filter on a 2013 Rogue?

Change the cartridge filter every time you change the oil. For a 2013 Rogue, that is typically every 3,000 to 5,000 miles, depending on your driving conditions and the oil type you use. Check your owner's manual for the exact interval recommended for your vehicle.

Is the filter wrench worth buying if I only change my oil once a year?

Yes. A cartridge filter wrench costs $12 to $25 and lasts for years. It is cheaper than paying a shop $40 to $60 for an oil change, and you will use it every time you service the vehicle. If you do not want to buy one, borrow from a friend or rent from an auto parts store.

Can I change the oil filter without draining the oil?

Yes. The cartridge filter can be changed independently of an oil change. However, most people change both at the same time because the filter housing is already open and you are under the vehicle anyway. If you are only replacing the filter, place a drain pan underneath to catch the small amount of oil that will spill.