The 2020 Charger Hellcat is a supercharged V8 that demands specific maintenance and fuel

The 2020 Dodge Charger Hellcat runs a 6.2-litre supercharged V8 engine that produces 707 horsepower and 645 pound-feet of torque. That power comes from a belt-driven supercharger bolted directly to the engine block, which forces air into the cylinders at high pressure. This is not a naturally aspirated engine, and it is not a turbocharged one — the supercharger spins at engine speed, so boost builds when ready when you press the throttle.

Because of that supercharger and the high compression ratio, the Hellcat requires premium fuel — 91 octane or higher in most of North America. Using regular 87-octane fuel will trigger knock, which is detonation inside the cylinders that damages pistons and valves. The engine's computer can retard timing to prevent knock, but that reduces power and increases heat. Over time, running regular fuel will shorten engine life.

The supercharger itself is a wear item. It spins at up to 14,000 rpm and relies on internal bearings and seals. Neglecting oil changes accelerates that wear because the supercharger depends on clean oil for lubrication. A supercharger rebuild or replacement costs between $3,000 and $5,000 in parts and labour, so maintenance is not optional.

Key Takeaways

  • The 2020 Hellcat requires premium fuel and will lose power and risk engine damage if you use regular 87-octane gasoline.
  • Oil changes are critical because the supercharger relies on clean oil; Dodge recommends every 3,000 miles or 3 months, whichever comes first.
  • The supercharger is a precision component that can cost $3,000 to $5,000 to rebuild or replace if it fails from neglect.
  • Transmission fluid and differential fluid also need regular changes because the Hellcat's power stresses both systems more than a standard Charger.

Oil and filter changes are more frequent than a standard Charger

Dodge specifies 3,000-mile or 3-month intervals for the Hellcat, not the 10,000-mile intervals that explore to non-supercharged Chargers. The supercharger generates heat and puts extra load on the oil, breaking it down faster. Skipping or delaying oil changes allows sludge to build up, which clogs the supercharger's internal passages and starves its bearings of lubrication.

Use Mopar 5W-30 synthetic oil or an equivalent synthetic that meets Chrysler's MS-13150 specification. Synthetic oil handles heat better than conventional and lasts longer, but it still needs changing at 3,000 miles. The oil filter should be changed every time; do not reuse it or extend the interval.

If you drive in severe conditions — towing, idling in traffic, dusty roads, or frequent short trips — Dodge recommends even more frequent changes. Check your owner's manual for the severe-duty schedule in your region.

Transmission and differential fluid require regular service

The 2020 Hellcat comes with an 8-speed automatic transmission (TorqueFlite 8HP95) or a 6-speed manual (Tremec TR6060). Both are strong transmissions, but the Hellcat's 707 horsepower stresses them more than a standard Charger's 370 horsepower does. Dodge does not publish a specific transmission fluid change interval for the Hellcat, but many owners and shops recommend servicing every 30,000 to 50,000 miles to extend transmission life.

The rear differential also needs attention. The Hellcat uses a 3.09:1 or 3.55:1 gear ratio depending on the model year and options. Dodge recommends differential fluid changes every 30,000 miles if you tow, drive in severe conditions, or use the car for track days. Even for street driving, many owners change it every 50,000 miles as preventive maintenance. Use Mopar 75W-90 synthetic gear oil or an equivalent meeting Chrysler's MS-9305 specification.

Cooling system and intercooler maintenance

The supercharger compresses air, which heats it. The Hellcat uses an air-to-liquid intercooler to cool that compressed air before it enters the engine. The intercooler has its own coolant loop separate from the engine's main cooling system. Both systems must be maintained.

Dodge specifies coolant changes every 10 years or 100,000 miles for the main cooling system. Use Mopar 5-year/100,000-mile coolant or equivalent. The intercooler coolant is part of the same system, so it gets changed on the same schedule. However, if you drive the car hard — track days, drag racing, or sustained high-speed driving — the intercooler works harder and the coolant degrades faster. Consider changing it every 50,000 miles if you use the car aggressively.

Check coolant level monthly. Low coolant reduces cooling capacity and can cause the engine to overheat, which will crack the supercharger housing or warp cylinder heads. Overheating also triggers limp mode, where the engine reduces power to protect itself.

Spark plugs and ignition system

The 2020 Hellcat uses iridium spark plugs, which last longer than copper plugs but still wear out. Dodge recommends replacement every 100,000 miles. However, because the supercharger and high compression ratio create more heat and pressure in the cylinders, some owners change plugs every 50,000 miles to reduce the risk of pre-ignition or knock.

Pre-ignition is different from knock. It occurs when fuel ignites before the spark plug fires, usually from a hot carbon deposit or a weak plug. Pre-ignition can destroy a piston in seconds. Using premium fuel and keeping the engine clean reduces the risk, but worn plugs make it more likely.

When you replace the plugs, use the exact specification: Mopar or equivalent iridium plugs gapped to 0.043 inches. Do not use a hotter plug or a colder plug than specified, and do not gap them differently. The engine's computer is tuned for the stock plug heat range.

Air filter and intake cleanliness

The supercharger draws air through the intake and air filter. A clogged filter reduces airflow, which lowers boost pressure and power. Dodge recommends inspecting the air filter every 15,000 miles and replacing it when it looks dirty. In dusty climates, that may be every 15,000 miles. In clean areas, it might be every 30,000 miles.

Do not install an aftermarket high-flow air filter without tuning the engine. The stock intake and filter are calibrated to the engine's computer. A different filter changes airflow, which can cause the oxygen sensors to read incorrectly and trigger a check engine light. If you want a high-flow filter, you will need a custom tune to compensate.

Carbon buildup on intake valves is also a concern on direct-injection engines like the Hellcat. Fuel sprays directly into the cylinders, so it does not wash the intake valves the way port injection does. Over time, carbon accumulates. Some owners use fuel system cleaners every 10,000 miles to slow this. A professional intake valve cleaning costs $300 to $600 and may be worth doing every 50,000 to 80,000 miles if you notice rough idle or hesitation.

Brake system and suspension wear

The Hellcat's weight (4,500 pounds) and power put stress on the brakes and suspension. The car comes with Brembo brakes and performance suspension tuned for handling, but they still wear faster than a standard Charger's components.

Brake pads should be inspected every 15,000 miles. Depending on driving style, they may last 30,000 to 50,000 miles. Brake fluid should be changed every 2 years or 30,000 miles because it absorbs moisture from the air, which lowers its boiling point and reduces braking power under hard use. If you track the car, change brake fluid every 12 months or before each event.

Suspension bushings and ball joints wear faster on a car with this much power because acceleration and cornering loads are higher. Have the suspension inspected every 30,000 miles. Worn bushings cause clunking sounds and reduce handling precision. Worn ball joints are a safety issue that can cause loss of control.

Battery and electrical system

The Hellcat's supercharger and high-output alternator put extra demand on the electrical system. The stock battery is adequate for normal driving, but track use or frequent hard acceleration can drain it faster. If you notice slow cranking or dim headlights, the battery may be weakening.

Dodge recommends battery replacement every 3 to 5 years. Use a battery rated for at least 800 cold-cranking amps (CCA) to may support reliable starting in cold weather. The alternator should be checked if the battery is draining quickly or the charging system warning light comes on.

Keep battery terminals clean and tight. Corrosion on the terminals increases resistance and reduces charging efficiency. Check them every 6 months and clean with baking soda and water if white or blue-green corrosion appears.

Frequently Asked Questions

Can I use regular 87-octane fuel in a Hellcat?

No. The engine requires 91 octane or higher. Using regular fuel triggers knock, which reduces power and damages pistons and valves over time. The engine's computer can retard timing to prevent knock, but that increases heat and shortens engine life. Always use premium fuel.

How often should I change the oil in a 2020 Hellcat?

Every 3,000 miles or 3 months, whichever comes first. The supercharger relies on clean oil for lubrication, and the engine generates more heat than a standard Charger. Skipping oil changes allows sludge to build up and damages the supercharger's internal bearings.

What happens if I ignore the transmission fluid change interval?

Transmission fluid breaks down over time and loses its ability to lubricate and cool the transmission. The Hellcat's 707 horsepower stresses the transmission more than a standard Charger does. Neglecting fluid changes leads to delayed shifts, overheating, and eventually transmission failure, which costs $3,000 to $5,000 to repair or replace.

Is the 2020 Hellcat reliable for daily driving?

Yes, if you follow the maintenance schedule. The engine and transmission are proven designs used in other Chrysler products. The main difference is that the Hellcat requires more frequent oil changes and premium fuel. Neglecting maintenance will cause problems, but regular service keeps the car reliable.

What should I do if the check engine light comes on?

Read the fault code with a diagnostic scanner. Common codes on Hellcats include knock detection (which may mean you used regular fuel), oxygen sensor faults (which may mean a clogged air filter or carbon buildup), and transmission pressure faults (which may mean low fluid). Do not ignore the light; have it diagnosed within a few days to prevent further damage.