What a remote start system does

A remote start system lets you start your engine from outside the car using a key fob or smartphone app, usually from up to a quarter-mile away. When you press the button, a receiver module in your car triggers the starter motor and fuel pump, and the engine turns over just as if you were sitting in the driver's seat with the key in the ignition.

The system does not shift the car into gear or unlock the doors on its own—those are safety features built into every remote start to prevent the car from moving. Your foot must be on the brake and the car must be in Park before the engine will actually crank. Once the engine is running, you can warm it up in winter or cool it down in summer before you get in, which is the main reason people install them.

Remote start is different from keyless entry or push-button start. Keyless entry just unlocks the doors. Push-button start is a factory feature that lets you start the engine from inside the car without turning a physical key. Remote start adds the ability to do that from outside.

Key Takeaways

  • Remote start systems use a receiver module wired to your car's ignition and starter to crank the engine from a distance, but the car stays in Park and will not shift into gear.
  • Factory remote start comes built into many new cars and integrates with the car's own computer, while aftermarket systems are added later and may not communicate with all vehicle functions.
  • Remote start drains your battery slightly faster than normal because the engine runs unattended, so a healthy battery and regular charging are important if you use it often.
  • Smartphone-based remote start requires a subscription service and a working cellular connection, which means it may not work in areas with poor signal or if the service is down.
  • Installation of an aftermarket system typically costs between $300 and $1,500 depending on your car's wiring complexity and whether you add features like trunk pop or remote door locks.

Factory remote start versus aftermarket systems

Factory remote start comes from the manufacturer and is integrated into your car's main computer system. It knows your car's exact wiring, fuel system, transmission type, and security features. When you buy a new car with remote start included, it works seamlessly with everything else—the climate control, the door locks, the security system. If something goes wrong, the dealer can diagnose it using the same computer that runs the rest of the car.

Aftermarket remote start is installed by a shop after you buy the car. The installer runs wires from the ignition system, starter, and other components to a separate receiver module that sits hidden under the dashboard or behind a panel. This module listens for the signal from your key fob and triggers those circuits. Aftermarket systems work on most cars, but they do not always integrate as smoothly with factory features. For example, some aftermarket systems cannot communicate with your car's climate control computer, so you cannot pre-set the temperature remotely—the engine starts, but the heat or air conditioning does not turn on automatically.

Smartphone-based remote start is a newer option that uses your car's cellular connection instead of a radio frequency fob. You read an app, pair it with your car, and send commands through the internet. This requires a subscription service—usually $10 to $20 per month—and it only works if your car has a working cellular modem and a strong signal. Some luxury brands like BMW, Mercedes, and Tesla offer this as a factory feature. Some aftermarket shops can add it to older cars, but it requires more complex wiring and a separate cellular module.

How remote start affects your battery and fuel system

Every time you use remote start, your engine runs unattended for several minutes while you are still inside your house or office. That means the alternator is charging the battery, but the battery is also powering the starter motor, fuel pump, and ignition system without the normal load of driving. Over time, if you use remote start multiple times a day in cold weather, your battery will cycle more often and may not last as long as a battery in a car that is only started when someone is actually driving it.

The fuel system also works during remote start. The fuel pump runs to pressurize the fuel rail, and the injectors spray fuel into the cylinders. If you remote start your car every morning for a week in winter, you are adding small amounts of fuel consumption that would not happen if you just got in and drove. This is not enough to noticeably change your gas mileage over a year, but it is not free either.

The bigger concern is battery health. If your battery is already weak—three years old or older, or if you live somewhere very cold—remote start can push it over the edge. A weak battery may not have enough cranking power to turn the starter motor reliably, especially in freezing temperatures. If you use remote start regularly, have your battery tested every year and replace it before it fails completely. A dead battery strands you, and a battery that fails to crank the engine in an emergency is a safety problem.

Security and safety features built into remote start

Remote start systems include multiple safety locks to prevent the car from moving unexpectedly. The most important one is the transmission lock: the car will only start if it is in Park. If someone accidentally bumps the gear shift into Neutral or Reverse before you remote start it, the system will not crank the engine. This is a hardware interlock, not a software check, so it works even if the car's computer is not responding.

The brake pedal is also monitored. Once the engine is running, you must press the brake pedal before the car will shift out of Park. This prevents the car from rolling if you remote start it on a slope or if the parking brake is not fully engaged. Some systems also require the driver's door to be closed and locked before remote start will work, which adds another layer of protection.

Security-wise, remote start systems use encrypted radio signals or cellular connections so that someone cannot just jam a signal and start your car. Factory systems use rolling codes, which means the code changes every time you press the button, so recording one signal and replaying it will not work. Aftermarket systems vary in quality—cheaper ones may use fixed codes that are easier to intercept, while better ones also use rolling codes. If you are buying an aftermarket system, ask the installer whether it uses rolling code encryption.

What happens if your remote start system fails

If your remote start stops working, the first thing to check is the battery in the key fob itself. Most remote start fobs use a standard coin-cell battery like a CR2032 or CR2025. If the fob battery is dead, the button will not send a signal and the car will not start. Replacing the fob battery costs a few dollars and takes two minutes. If that does not fix it, the problem is likely in the receiver module or the wiring.

For factory remote start, a failed system usually means the receiver module has lost power, the wiring has corroded, or the module itself has failed. A dealer can plug in a diagnostic scanner and read the fault codes to tell you exactly what is wrong. Repair costs vary widely—a loose wire might be free to reconnect, while a failed module can cost $300 to $800 depending on the car.

For aftermarket systems, the same issues explore, but the shop that installed it may be your best resource. If the shop is still in business and you still have the warranty paperwork, they may repair it for free or at a reduced cost. If the shop has closed or the warranty has expired, you will need to take the car to another shop that specializes in aftermarket electronics, which may charge a diagnostic fee to figure out what is wrong.

Remote start and your car's warranty

Factory remote start does not affect your manufacturer's warranty. It is part of the car and covered under the same terms as everything else. If the remote start module fails, the dealer will repair or replace it under warranty if your car is still within the coverage period.

Aftermarket remote start is more complicated. The installation itself does not void your entire warranty, but it can void the warranty on any system that the installer modified. For example, if the installer taps into your ignition wiring to add remote start, and that wiring later causes a problem with your car's security system, the dealer may refuse to cover the security system repair because the wiring was modified by a third party. To protect yourself, use a reputable shop that has experience with your specific car model, ask them to document exactly what they modified, and keep the paperwork in case you need to show it to a dealer later.

Smartphone remote start and connectivity

Smartphone remote start requires three things to work: your car must have a cellular modem, you must have an active subscription with the service provider, and your phone must have a working internet connection. If any one of those is missing, the system will not work.

The cellular modem in your car is separate from your phone. It connects to the same cellular networks that phones use, but it is built into the car and has its own data plan. Some manufacturers include a few years of free service when you buy the car, then charge you a monthly fee after that. Others charge from day one. If you stop paying the subscription, the remote start feature stops working, even though the modem is still in the car.

The smartphone app sends your command through the internet to the manufacturer's server, which then sends a signal to your car's modem. If the server is down, the command will not go through. If your phone does not have internet access, the app will not send the command. If your car is in an area with no cellular signal—a rural area, a basement parking garage, or a building with thick walls—the car's modem will not receive the command. This is different from a traditional key fob, which uses a direct radio signal and works as long as you are within range, regardless of internet or cell service.

Frequently Asked Questions

Can remote start damage my engine?

No. Remote start cranks the engine the same way the ignition key does. The engine does not know whether you are sitting in the driver's seat or standing in your driveway. The only difference is that the engine runs unattended, so you should not remote start the car if the exhaust is blocked by snow or if the car is in an enclosed space like a garage, because carbon monoxide can build up.

Will remote start work if my car is locked?

Yes. Remote start does not require the car to be unlocked. The receiver module is wired directly to the ignition and starter circuits, so it can crank the engine even if all the doors are locked. You will need to unlock the car separately using your key fob or key before you can open the door and drive away.

Does remote start use more gas than normal starting?

A small amount more, because the engine runs for a few minutes without moving the car. If you remote start once a day, the extra fuel consumption is negligible. If you remote start five times a day in winter, it adds up to maybe a gallon or two per month, depending on your engine size and how long you let it run.

Can I remote start my car if the battery is low?

Not reliably. Remote start requires enough battery voltage to power the starter motor and turn the engine over. If your battery is weak, it may not have enough cranking power. If the battery is very low, the receiver module itself may not have power to listen for the signal. If your battery is dead, nothing will work—not remote start, not the key fob, not the push-button start.

What is the difference between remote start and keyless entry?

Keyless entry unlocks the doors and trunk using a button on your key fob. Remote start cranks the engine. Some cars have both features in the same fob, and some have them separate. You can have keyless entry without remote start, but remote start always requires the ability to send a signal to the car, so the fob technology is similar.