You can replace a Subaru key fob battery yourself with a coin and a new battery
Most Subaru key fobs use a coin-cell battery (usually CR2032 or CR2025) that you can swap out at home without tools beyond a coin. The whole job takes about five minutes. You do not need to visit a dealer or a locksmith — the battery is the only part that wears out, and Subaru designs the fob to open from the side so you can reach it.
The exact battery type depends on your model year and fob design, but you can find the right one by checking your owner's manual or by looking at the old battery once you open the fob. Replacement batteries cost between $3 and $8 at any pharmacy, grocery store, or hardware store.
Key Takeaways
- Subaru key fobs open by sliding a coin into the seam on the side and twisting gently to separate the two halves.
- The battery type is printed on the old battery itself, so you can match it exactly when you buy a replacement.
- CR2032 and CR2025 are the most common Subaru fob batteries, and both are stocked at pharmacies and grocery stores.
- After inserting the new battery with the positive side facing up, snap the fob halves back together and test the buttons before you rely on it.
What battery type your Subaru key fob uses
The battery type is stamped directly on the old battery, so the easiest way to know what to buy is to open the fob first and look. Most Subaru fobs from the last 15 years use either a CR2032 (the most common) or a CR2025. Both are coin-cell batteries about the size of a dime.
If you want to check before opening the fob, your owner's manual lists the battery type in the key fob section. You can also call your Subaru dealer with your vehicle identification number (VIN) and model year, and they will tell you over the phone. Online Subaru forums and parts sites also list the battery by model year if you search for your specific generation.
How to open the key fob
Look at the side edge of your fob for a small seam or slot. Insert a coin (a dime or penny works) into that slot and twist gently — do not force it. The two halves of the fob will separate. Some fobs have the slot on the bottom edge instead of the side, so check both if you do not see it right away.
Once the fob is open, you will see the battery sitting in a small metal holder. Note which side is facing up (the positive side, marked with a + symbol, should face toward you). Gently pry the old battery out with the edge of your coin or your fingernail — it is not glued in, just resting in the holder.
Installing the new battery
Place the new battery into the holder with the positive side facing up, the same way the old one was oriented. Press down gently until it sits flat and clicks into place. Do not force it — the battery should rest snugly without pressure.
Snap the two halves of the fob back together by pressing them firmly until you hear or feel a click. The seam should be flush all the way around. If there is a gap, the halves are not fully seated — open it again and check that the battery is not sitting too high.
Testing your fob after replacement
Before you put the fob away, test each button — lock, unlock, and panic if your fob has one. Stand near your Subaru and press each button to confirm the doors lock and unlock. If a button does not work, open the fob again and check that the battery is seated correctly and facing the right direction.
If the fob still does not work after reseating the battery, the battery itself may be defective (rare but possible). Try a different new battery from a different package or store. If the fob still fails, the internal circuit may be damaged, and you will need a replacement fob from your dealer.
Where to buy replacement batteries
CR2032 and CR2025 batteries are sold everywhere: pharmacies (CVS, Walgreens), grocery stores, hardware stores (Home Depot, Lowe's), and online retailers. A single battery usually costs $3 to $5, though multi-packs are often cheaper per battery. You do not need a special "car battery" — a standard coin-cell battery from any source works fine.
Keep a spare battery in your glove box or at home so you are not caught with a dead fob. Batteries last two to four years depending on how often you use the fob, so if you replace one, mark the date on the new package so you know when to expect the next one to fail.
What to do if the fob will not open
If the seam is too tight to fit a coin, try a flathead screwdriver instead — insert it gently and twist slowly. Do not pry hard or you may crack the plastic. If the fob is very old or has been dropped, the seam may be stuck from corrosion or damage. Soak the edge in warm water for a few minutes to loosen any corrosion, then try again.
If you still cannot open it, a locksmith or your Subaru dealer can open it for you and replace the battery. This costs more than doing it yourself, but it is an option if the fob is physically stuck. Do not attempt to drill, cut, or hammer the fob open — you will destroy the circuit board inside.
Frequently Asked Questions
How long does a Subaru key fob battery last?
Most coin-cell batteries last two to four years in a key fob, depending on how often you press the buttons. If you use your fob multiple times a day, the battery may wear out sooner. If you rarely use it, it may last longer.
Can I use a different battery type if I cannot find the exact one?
No — use the exact type printed on your old battery. CR2032 and CR2025 are similar in size but have different voltage and capacity, and using the wrong one may cause the fob to malfunction or drain quickly. Buy the correct type; it is inexpensive and widely stocked.
What if my Subaru key fob has two batteries?
Some older Subaru fobs use two smaller batteries instead of one large one. If you open the fob and see two batteries, replace both at the same time. They are usually the same type, but check both to be sure.
Do I need to reprogram my fob after changing the battery?
No — replacing the battery does not erase the fob's programming. Once you install the new battery and close the fob, it will work when ready without any reprogramming steps.
Is it safe to handle the battery with my bare hands?
Yes — coin-cell batteries are safe to touch. Wash your hands afterward if you prefer, but there is no risk from handling the battery briefly during replacement.