Strut replacement typically costs between $400 and $1,200 per axle, depending on your vehicle, the shop, and whether you replace one or both sides at once

A single strut assembly—the shock absorber, spring, and mounting hardware combined—runs $150 to $400 in parts alone. Labor adds $250 to $800 per axle because the job requires removing the wheel, disconnecting the brake line, unbolting the steering knuckle, and compressing the spring under pressure. Most shops charge $100 to $200 per hour, and this work takes two to four hours per side depending on how corroded the bolts are and whether your vehicle sits low to the ground.

The final bill depends on four things: what kind of strut you buy, whether you do both sides or one, which shop does the work, and how much rust has seized the old bolts. A Honda Civic costs less to service than a Range Rover. An independent shop usually charges less than a dealership. And a car that has sat in road salt for ten winters will take longer to disassemble than one from Arizona.

Key Takeaways

  • Strut replacement costs $400 to $1,200 per axle in total, with parts ranging $150 to $400 and labor $250 to $800 depending on your vehicle and location.
  • Dealerships typically charge 30 to 50 percent more than independent shops for the same work, though they may use original manufacturer parts.
  • Replacing both struts on the same axle at the same time prevents uneven handling and is usually cheaper per strut than doing one now and one later.
  • Heavily rusted bolts, low-sitting vehicles, and complex suspension designs can add hours to the job and increase labor costs significantly.
  • Aftermarket struts cost less upfront but may wear out sooner than OEM or quality replacement brands, affecting your long-term repair budget.

Why strut replacement is not a one-price job

The parts themselves vary wildly. A basic aftermarket strut assembly for a Toyota Camry might cost $120 to $180 per side. An OEM (original equipment manufacturer) strut for the same car runs $250 to $350. A performance or heavy-duty strut designed for towing or off-road use can exceed $400 per side. The cheaper option gets you back on the road; the expensive option may last longer and handle better.

Labor time is not fixed either. A strut on a sedan with good access and no rust might take ninety minutes. The same strut on a truck with a lifted suspension, or on any vehicle where the bolts have corroded solid, can take three to four hours. Some shops charge a flat rate for the job; others charge hourly. Flat-rate shops may quote $600 for both front struts on a common sedan, while an hourly shop might charge $150 per hour for four hours of work—the same $600, but the math is different if complications arise.

Dealership versus independent shop pricing

Dealerships typically charge 30 to 50 percent more than independent suspension shops for strut replacement. A dealership might quote $1,400 for both front struts on a mid-size sedan; an independent shop might quote $900 for the same work. The dealership usually stocks OEM parts and may offer a longer warranty on the work itself. The independent shop often uses quality aftermarket parts and may have faster turnaround because they are not backed up with warranty claims and recalls.

Neither is always the right choice. If your vehicle is still under warranty, a dealership repair protects that coverage. If your car is ten years old and you want the cheapest honest work, an independent shop with good reviews is usually the better bet. Ask both for a written quote that lists the parts brand, the labor hours, and any warranty on the work—not just the total price.

One strut or both: the real cost of doing it halfway

Replacing only one strut when both are worn creates an imbalance. The new strut is stiffer; the old one is softer. Your car will sit slightly higher on one side, and the suspension will handle unevenly—the vehicle may pull to one side under braking or feel unstable in a turn. You will likely be back at the shop within a year to replace the other one, paying labor a second time.

Replacing both struts on the same axle at the same time costs more upfront but prevents this problem and usually saves money per strut because the shop is already under the car. If you have $600 and both struts are worn, ask the shop whether they can do both for that price or whether you should wait and save for the full job. Many shops will negotiate on the total if you commit to both sides at once.

What makes the job take longer and cost more

Rust is the biggest wildcard. In states with winter road salt, the bolts that hold the strut to the steering knuckle and the frame can seize solid. A shop may need to explore penetrating oil, wait, explore heat, and use specialized tools to break them loose without stripping the bolt head. This can add one to two hours to the job. A vehicle from a dry climate might take half that time.

Suspension design matters too. Some vehicles have struts that bolt directly to the frame with straightforward access. Others have complex multi-link suspensions where the strut is buried under other components. A luxury sedan or SUV might take twice as long as a basic compact car. Low-riding vehicles and those with aftermarket lowering springs require extra care because the spring is under more pressure and the clearance is tighter.

Brake line disconnection adds time if the line is corroded or if the shop needs to bleed the brake system afterward. Some vehicles require wheel alignment after strut replacement; others do not. Ask the shop whether alignment is needed for your car—it usually costs $100 to $200 extra if it is.

Strut quality and how it affects long-term cost

A cheap aftermarket strut might cost $100 per side but wear out in 40,000 to 60,000 miles. A mid-range strut costs $200 to $250 and typically lasts 60,000 to 80,000 miles. A quality OEM or premium aftermarket strut costs $300 to $400 and often lasts 80,000 to 100,000 miles or more. Over the life of your car, the expensive strut might actually cost less per mile because you replace it fewer times.

The warranty on the part matters. Many aftermarket struts come with a one-year or two-year warranty against defects. OEM struts often have a longer warranty or are covered under your vehicle's remaining factory warranty. A strut that fails at 50,000 miles is worthless savings if you have to pay labor again to replace it.

When to replace struts and how to avoid the full cost

Struts wear gradually, so you do not wake up one morning needing them replaced. Signs include a bouncy or soft ride, nose-diving under braking, excessive body roll in turns, or uneven tire wear. If you catch the wear early—when the ride is just starting to feel loose—you can plan the repair instead of having it forced on you by a failure.

Some shops offer a suspension inspection for $50 to $100. A technician will put the car on a lift, push down on each corner, and feel how quickly it rebounds. If the strut is leaking oil or the rebound is very slow, replacement is due soon. This inspection lets you schedule the work at your convenience rather than in an emergency, and it gives you time to get quotes from multiple shops.

Regional and seasonal pricing differences

Strut replacement costs vary by region. Labor rates in urban areas and wealthy suburbs are typically 20 to 40 percent higher than in rural areas. A shop in San Francisco or Boston might charge $180 per hour; a shop in a small town might charge $100 per hour. Parts availability also varies—a common vehicle model is cheaper to service anywhere, but an unusual or imported vehicle might cost more in areas where fewer shops stock the parts.

Seasonal demand affects turnaround time and sometimes price. In spring and fall, when people service their cars before long trips, shops are busier and may charge more or have longer wait times. Winter in cold climates is also busy because rust and salt damage become visible. If you can schedule the work in summer or early fall in a cold climate, you may get faster service and potentially better pricing.

Frequently Asked Questions

Can I replace just the front struts and leave the rear alone?

Yes, front and rear struts wear independently. Many cars need front strut replacement before the rear. However, if both are worn, replacing only the front will make the rear feel even softer by comparison, creating an unbalanced ride. Have the shop inspect all four struts and tell you which ones actually need replacement.

Do I need an alignment after strut replacement?

It depends on your vehicle. Front strut replacement can shift the wheel angle slightly, so many shops recommend a four-wheel alignment afterward for $100 to $200. Some vehicles hold alignment better than others. Ask the shop whether alignment is necessary for your specific car before you approve the work.

What is the difference between a strut and a shock absorber?

A strut is a complete assembly that includes the shock absorber, the spring, and the mounting hardware all in one unit. A shock absorber is just the damping part. Most modern cars use struts on the front; some use shocks on the rear. Struts are more expensive because they do more work.

How long does strut replacement take?

Two to four hours per axle, depending on rust, vehicle design, and whether complications arise. A shop doing both front struts on a common sedan with good access might finish in three to four hours total. A truck with rust and a complex suspension might take six to eight hours.

Is it worth buying expensive OEM struts instead of cheap aftermarket ones?

It depends on how long you plan to keep the car and how much you drive. If you keep the car for ten years and drive 15,000 miles per year, a quality strut that lasts 100,000 miles saves you a second replacement. If you plan to sell the car in three years, the cheap strut is probably fine as long as it lasts until then.