Electric power steering systems fail in ways that range from annoying to dangerous, and repair costs depend almost entirely on what broke inside the unit
Electric power steering (EPS) uses a motor and computer to information your steering instead of a hydraulic pump. When it malfunctions, you lose power information — the wheel becomes hard to turn, especially at low speeds — but you do not lose the ability to steer. The repair cost depends on whether the problem is a sensor, the motor itself, the control module, or the wiring. A faulty sensor might run $200 to $400 in parts and labor. A failed motor or control module typically costs $800 to $2,000. A complete steering column replacement can exceed $3,000.
The first step is always a diagnostic scan. A shop will plug in a code reader to pull the specific fault code from your vehicle's computer. That code tells you whether the problem is electrical, mechanical, or software-related. Many shops charge $100 to $150 for this scan, though some waive it if you proceed with repairs there. Do not skip this step — guessing at EPS problems is expensive.
Key Takeaways
- A diagnostic scan costs $100 to $150 and tells you exactly which component failed, which determines whether repair will cost $300 or $2,000.
- Sensor failures are the cheapest fix; motor and control module failures are the most expensive and often require replacement rather than repair.
- Some EPS problems stem from low battery voltage or corroded electrical connections, which a shop can fix for under $200.
- If your steering wheel locks or becomes completely unresponsive while driving, pull over safely and have the vehicle towed rather than continuing to drive.
How to read the warning signs before a breakdown
The steering wheel becoming stiff or heavy is the most common early warning. You might notice it only when turning at low speeds or parking, or it might happen constantly. Some drivers report a whining noise from the steering column when turning. Others see a warning light on the dashboard — usually labeled "EPS," "Power Steering," or a steering wheel icon.
A second warning is intermittent loss of power information. The steering feels normal one moment, then suddenly heavy, then normal again. This pattern often points to a failing sensor or a loose electrical connection. Do not ignore it. Intermittent electrical problems in steering systems tend to get worse, and the failure can become complete without warning.
Steering that locks up completely while driving is rare but serious. If this happens, pull over to a safe location when ready and call for a tow truck. Attempting to drive with a locked steering column is dangerous and can cause a crash.
Sensor failures versus motor and module failures
Sensors in the steering column measure the angle and torque of your steering input and send that data to the control module. The module then tells the motor how much information to provide. A faulty sensor is the cheapest problem to fix — typically $200 to $500 total, including labor. Shops can usually replace a sensor without removing the entire steering column.
Motor and control module failures are more expensive because they require more labor to access and because replacement is usually the only option. A steering motor costs $400 to $800 in parts alone; labor to remove and install it adds another $300 to $600. A control module runs $300 to $1,200 in parts, plus $200 to $400 in labor. Some vehicles also require reprogramming after a module replacement, which adds another $100 to $300.
Wiring and connector problems fall in the middle. Corroded connectors, damaged wiring harnesses, or loose grounds can cause EPS failure and cost $150 to $600 to repair. A shop can often spot these during the diagnostic scan by checking voltage and resistance at key connection points.
Why battery voltage matters more than you think
Electric power steering draws significant current from your battery, especially when turning. If your battery is weak or your alternator is not charging properly, the EPS system may shut itself off as a safety measure. This feels like a steering failure but is actually the system protecting itself from electrical damage.
Before paying for steering repairs, have your battery and alternator tested. Many auto parts stores do this for free. If your battery voltage is below 12 volts at rest or your alternator is not outputting 13.5 to 14.5 volts while the engine runs, fix that first. A new battery costs $100 to $200; a new alternator runs $300 to $800. Either is cheaper than unnecessary steering work, and it may solve the steering problem entirely.
When to replace the entire steering column versus repair components
Some vehicles have steering columns where the motor, sensor, and wiring are integrated into a single assembly. On these cars, a single failed component sometimes means replacing the whole column. Other vehicles have modular designs where you can replace just the failed part. Your vehicle's design determines this, not the shop's preference.
Ask the shop whether they can replace the specific failed component or whether the column design requires a full replacement. If a full replacement is necessary, get a quote for both new and remanufactured columns. A remanufactured column costs 30 to 50 percent less than new and carries a warranty, usually 12 months or 12,000 miles. The labor cost is the same either way.
Full column replacement typically costs $1,500 to $3,500 depending on your vehicle. This is the most expensive EPS repair scenario, but it is sometimes unavoidable. If you are facing this cost, get quotes from at least two shops before deciding.
Aftermarket versus OEM parts and warranty differences
Original equipment manufacturer (OEM) parts come from your vehicle's maker or an authorized distributor. Aftermarket parts come from third-party suppliers. For EPS components, the price difference can be significant. An OEM motor might cost $600; an aftermarket equivalent might be $350. An OEM control module might be $900; aftermarket might be $500.
The trade-off is warranty and reliability. OEM parts typically carry a 12-month or 24-month warranty. Aftermarket parts vary widely — some carry only 30 days, others offer 12 months. Ask the shop what warranty they provide on parts and labor before you commit. A $200 savings on parts means nothing if the part fails in six months and you have to pay labor again.
Remanufactured OEM parts are a middle ground. These are used parts that have been rebuilt to factory specifications and tested. They cost less than new OEM parts but more than new aftermarket parts, and they usually carry a 12-month warranty. For EPS motors and modules, remanufactured OEM is often the best value.
What to expect during the repair process and timeline
A straightforward sensor replacement usually takes 1 to 2 hours. The shop removes the steering column cover, disconnects the sensor, and installs the new one. You might have your car back the same day.
A motor or module replacement takes 3 to 5 hours because the steering column must be partially disassembled. Some vehicles require the steering wheel to be removed and the column to be dropped from the dashboard. If reprogramming is needed, add another 1 to 2 hours. Most shops can complete this work in one day, but some may need two.
A full steering column replacement can take 6 to 10 hours. The shop must remove the steering wheel, disconnect all electrical connectors, remove mounting bolts, and install the new column. Alignment and testing add time. Expect this work to take a full day or more.
Ask the shop for a timeline before they start work. If they cannot give you one, ask why. Unexpected delays usually mean they discovered additional damage or complications, which will cost you more money.
Frequently Asked Questions
Can I drive with a broken electric power steering system?
Yes, but with difficulty. You retain manual steering ability — the wheel will just be harder to turn, especially at low speeds and when parking. If the system fails completely while you are driving, pull over safely. Do not attempt to drive long distances with failed power steering.
Will my check engine light come on if the power steering fails?
Usually yes. The EPS system is monitored by your vehicle's computer, and a fault triggers a warning light. It might say "EPS," "Power Steering," or display a steering wheel symbol. Some vehicles also trigger the check engine light. Either way, have the system scanned to identify the specific problem.
How much does it cost to replace the entire steering column?
Full column replacement typically ranges from $1,500 to $3,500 in parts and labor, depending on your vehicle make and model. A remanufactured column costs 30 to 50 percent less than a new one. Get quotes from two shops before deciding, as prices vary significantly by location and vehicle.
What causes electric power steering to fail?
The most common causes are sensor failure, motor burnout, control module failure, and electrical connection problems. Low battery voltage or a failing alternator can also trigger EPS shutdown. A diagnostic scan identifies which component failed and guides the repair.
Is electric power steering repair covered by warranty?
If your vehicle is still under manufacturer warranty, EPS repairs are usually covered. Check your warranty paperwork or contact your dealer. If you are out of warranty, the repair is your responsibility, though the shop's warranty on parts and labor typically covers the repair for 12 months or 12,000 miles.