Tie rod replacement typically costs between $150 and $500 per side at a shop, depending on whether you need an inner tie rod, outer tie rod, or both, and whether your vehicle is domestic or imported.

A tie rod is a steering component that connects your wheel hub to the steering rack. When it wears out, your steering becomes loose or pulls to one side. Replacement is not optional—a failed tie rod can make the vehicle unsafe to drive.

The total bill depends on three things: which tie rod has failed (inner, outer, or both), your vehicle's make and model, and whether the shop needs to do a wheel alignment afterward. Inner tie rods are usually more expensive to replace because the steering rack must be partially disassembled to reach them.

Key Takeaways

  • Outer tie rod replacement costs $150 to $300 per side; inner tie rod replacement costs $200 to $400 per side, because the steering rack must be accessed.
  • Parts alone run $50 to $150 per tie rod, so labor makes up the majority of the bill.
  • A wheel alignment after replacement costs $75 to $200 and is necessary to prevent uneven tire wear.
  • Replacing both tie rods at once (if both are worn) costs less in labor than doing them separately, because the mechanic does not have to remove and reinstall components twice.

Outer vs. Inner Tie Rod Replacement Costs

An outer tie rod connects the steering rack to the steering knuckle at the wheel. It is easier to access and takes 30 to 60 minutes to replace. Most shops charge $150 to $300 in labor, plus $50 to $100 for the part itself. Total: roughly $200 to $400 per side.

An inner tie rod is threaded into the steering rack itself. To replace it, the mechanic must remove the outer tie rod, remove the steering rack boot (the rubber accordion that protects the joint), unscrew the inner tie rod from the rack, and install a new one. This takes 1 to 2 hours. Labor runs $200 to $400, plus $75 to $150 for the part. Total: roughly $275 to $550 per side.

Some vehicles have tie rods that are not serviceable separately—the entire steering rack assembly must be replaced, which costs $800 to $2,000 or more. Ask your mechanic whether your vehicle allows individual tie rod replacement before you get a quote.

Labor Time and Shop Rates

Labor cost depends on your mechanic's hourly rate and how long the job takes. Independent shops typically charge $75 to $150 per hour; dealerships charge $120 to $200 per hour. A single outer tie rod takes 0.5 to 1 hour; an inner tie rod takes 1 to 2 hours.

If both tie rods on one side have failed, replacing them together saves money. The mechanic removes the steering rack boot once and accesses both components in a single job, rather than removing and reinstalling parts twice. You might pay $350 to $600 for both instead of $400 to $700 if done separately.

If tie rods on both sides have failed, the total bill is roughly double a single-side replacement, minus a small savings on alignment. Some shops offer a discount if you replace all four (both sides, inner and outer), but this is only necessary if all four are actually worn.

Wheel Alignment After Replacement

After a tie rod is replaced, the vehicle's wheel alignment will be off. The steering angle and toe (the angle of the wheels relative to the centerline of the vehicle) change when you remove and reinstall the tie rod. Driving without realignment causes uneven tire wear and steering pull.

A two-wheel alignment (front wheels only) costs $75 to $150. A four-wheel alignment costs $150 to $200. Most shops include alignment in the tie rod replacement quote, but confirm this before you approve the work. If alignment is not mentioned, ask for it to be added.

Parts Cost Breakdown

Tie rod parts themselves are inexpensive compared to labor. An outer tie rod assembly costs $50 to $100. An inner tie rod costs $75 to $150. OEM (original equipment manufacturer) parts from the dealership are usually 20 to 40 percent more than aftermarket parts from suppliers like NAPA or AutoZone.

For most vehicles, aftermarket tie rods are reliable and carry a one-year warranty. OEM parts carry longer warranties (sometimes lifetime) and are may provide to fit, but the price difference rarely justifies the extra cost unless your vehicle is high-mileage or you plan to keep it for many more years.

Some shops charge a core fee ($10 to $25) if you do not return the old tie rod. Ask whether this applies before you approve the work.

Domestic vs. Imported Vehicle Costs

Domestic vehicles (Ford, Chevrolet, Dodge, Jeep) typically have lower parts costs and faster labor times because tie rods are simpler to access. Expect $200 to $400 per outer tie rod and $275 to $500 per inner tie rod.

Imported vehicles (Honda, Toyota, Nissan, Volkswagen, BMW) often have more complex steering geometry and tighter engine bays. Parts may cost 10 to 30 percent more, and labor may take longer. Expect $250 to $450 per outer tie rod and $350 to $600 per inner tie rod. Luxury brands (BMW, Mercedes, Audi) can run $400 to $700 per tie rod because parts are more expensive and labor rates are higher.

When to Replace Tie Rods and Warning Signs

Tie rods wear out gradually. Early signs include a loose or spongy steering feel, a clunking noise from the front end when turning, or uneven tire wear on the inside edge of the tire. If you notice any of these, have the steering inspected before the tie rod fails completely.

A completely failed tie rod can cause sudden loss of steering control. If your steering suddenly becomes very loose or you hear a loud clunk followed by the wheel moving freely, do not drive the vehicle. Have it towed to a shop.

Tie rods typically last 70,000 to 100,000 miles, but this varies by driving conditions. Rough roads, potholes, and aggressive driving wear them faster. If you have hit a pothole or curb hard, have the steering inspected even if you do not notice symptoms yet.

Getting a Quote and Comparing Shops

Call three shops and ask for a written estimate that includes the specific tie rod (inner, outer, or both), the parts cost, the labor cost, the alignment cost, and the warranty on parts and labor. Do not rely on phone quotes—written estimates protect you if the shop tries to add charges later.

Ask whether the shop will inspect the other tie rod while it has the vehicle apart. If one tie rod is worn, the other is often close behind. Replacing both at once saves money on labor and alignment.

Check online reviews for each shop on Google, Yelp, or the Better Business Bureau. Look for complaints about steering work specifically, not just general reviews. A shop with good reviews on brakes but poor reviews on suspension work may not be the best choice for tie rods.

Frequently Asked Questions

Can I drive with a bad tie rod?

Not safely. A worn tie rod causes loose steering and uneven tire wear, but a failed tie rod can cause sudden loss of steering control. If you notice clunking or very loose steering, have it inspected when ready. Do not drive long distances.

Is it cheaper to replace both tie rods at once?

Yes, slightly. If both are worn, replacing them in one visit saves labor time because the mechanic does not have to remove and reinstall the steering rack boot twice. You also pay for alignment once instead of twice. The savings are usually $100 to $200.

Do I need an alignment after tie rod replacement?

Yes. Removing and reinstalling a tie rod changes the wheel alignment. Without realignment, your tires will wear unevenly and steering may pull to one side. Alignment costs $75 to $200 and should be included in the tie rod replacement quote.

What is the difference between OEM and aftermarket tie rods?

OEM parts come from the vehicle manufacturer and cost 20 to 40 percent more. Aftermarket parts are made by third-party suppliers and are usually reliable with a one-year warranty. For most vehicles, aftermarket is sufficient unless you have very high mileage or plan to keep the vehicle long-term.

How long does tie rod replacement take?

An outer tie rod takes 30 to 60 minutes. An inner tie rod takes 1 to 2 hours. If both are being replaced, add 30 to 60 minutes. Alignment adds another 30 to 60 minutes. Total time is usually 2 to 4 hours for a complete job.