What an RV water filter housing does
An RV water filter housing is a container that holds a replaceable cartridge to clean water before it enters your fresh water tank or lines. The housing screws onto your RV's water inlet — usually located on the exterior wall near the fresh water connection — and catches sediment, chlorine, and other particles that come from campground spigots or other water sources.
The cartridge inside does the actual filtering. When water flows through, the cartridge traps debris and contaminants. Over time, the cartridge gets clogged and stops working well, so you replace just the cartridge rather than the entire housing. The housing itself is the permanent part that stays on your RV.
Most RV owners use a filter housing to avoid cloudy water, bad taste, or damage to their water pump and plumbing. Campground water quality varies widely, and a filter housing gives you control over what enters your system.
Key Takeaways
- RV water filter housings screw onto your exterior water inlet and hold a replaceable cartridge that filters sediment and chlorine from incoming water.
- You replace only the cartridge inside the housing, not the entire unit, usually every 3 to 12 months depending on water quality and how much you use your RV.
- Common cartridge types include sediment filters, carbon filters, and combination filters, each designed to remove different contaminants.
- A clogged or failing filter housing shows up as low water pressure, cloudy water, or a bad taste, and replacing the cartridge usually fixes the problem.
Types of filter cartridges and what they remove
Sediment filters are the most common type. They trap sand, silt, rust, and other particles that make water look cloudy or discolored. A sediment cartridge typically has a micron rating — 5 microns, 20 microns, or higher — that tells you how small the particles it catches are. Lower micron ratings catch finer particles but clog faster.
Carbon filters remove chlorine, odor, and some chemical tastes. If your campground water smells like a swimming pool, a carbon cartridge will help. Carbon does not remove sediment, so many RV owners use a combination cartridge that does both sediment and carbon filtering in one unit.
Specialty cartridges exist for specific problems — some remove iron, others reduce bacteria or viruses, and some are designed for well water. Check your RV manual or the housing label to see what cartridge size and type your housing accepts. Common sizes include 10-inch and 20-inch cartridges, and they are not interchangeable.
How to know when to replace the cartridge
Water pressure dropping is the clearest sign. When the cartridge clogs, water has to push harder to get through, so your shower pressure or sink flow weakens noticeably. If you have a pressure gauge on your housing, a drop from your normal reading means the cartridge is getting full.
Cloudy or discolored water means the sediment cartridge is no longer catching particles. Bad taste or smell that a carbon filter should have removed also signals replacement time. Some housings have a bypass valve that lets water flow around a clogged cartridge to keep your pressure up, so you might not notice pressure loss — but you will notice the water quality getting worse.
Cartridge life depends on your water source and how often you use your RV. Campground water with high sediment might require a new cartridge every 3 months, while cleaner sources might go 12 months or longer. Many RV owners replace cartridges seasonally or at the start of a trip as routine maintenance.
Steps to replace a filter cartridge
Turn off the water supply at your RV's inlet valve or at the campground spigot. Open a faucet inside your RV to release pressure in the lines. This step prevents water from spraying when you open the housing.
Unscrew the housing bowl — the large cylindrical part at the bottom — by hand or with a filter wrench if it is tight. Water will drain out, so have a bucket ready. Remove the old cartridge and dispose of it. Rinse the inside of the housing bowl with clean water to remove sediment buildup.
Insert the new cartridge into the housing, making sure it seats properly at the bottom. Screw the bowl back on by hand until it is snug, then tighten it another quarter turn with a wrench if needed. Do not over-tighten. Turn the water back on and check for leaks around the bowl seam. If water drips, tighten the bowl slightly more.
Where to buy replacement cartridges
RV supply stores and online retailers carry the most common cartridge sizes and types. Amazon, Camping World, and specialty filter retailers stock 10-inch and 20-inch sediment and carbon cartridges. Local hardware stores sometimes carry them, though selection is usually smaller.
Before you buy, check your housing for a label or model number that tells you the cartridge size and type. If the label is worn off, measure the cartridge length and diameter, or bring the housing to a store and match it to a display model. Buying the wrong size wastes money and leaves you without filtration.
Bulk buying cartridges makes sense if you use your RV frequently or travel to areas with poor water quality. Buying a year's worth at once is cheaper per cartridge than buying one at a time, and you will always have a spare on hand.
Maintenance and troubleshooting common problems
Leaking around the bowl seam is usually caused by an over-tightened or under-tightened bowl, or a worn rubber gasket inside the bowl. Tighten the bowl first. If that does not work, unscrew the bowl, remove the old gasket, and replace it with a new one. Gaskets are inexpensive and available wherever cartridges are sold.
Water bypassing the cartridge — flowing around it instead of through it — happens when the cartridge is not seated properly or when the bypass valve opens because pressure got too high. Remove the cartridge, check that the bottom is clean and undamaged, and reinstall it. If the problem continues, the bypass valve may be stuck or faulty and the housing may need service.
Slow water pressure that does not improve after cartridge replacement suggests a problem upstream — a clogged inlet screen at the spigot connection, or a kinked hose. Check your inlet hose and the campground connection before assuming the housing is faulty.
When to upgrade or replace the entire housing
Most RV water filter housings last many years if you replace cartridges regularly. Replace the entire housing if the bowl cracks, the threads strip, or the bypass valve fails and cannot be repaired. A cracked bowl will leak no matter what you do, and stripped threads mean the bowl will not seal.
Some RV owners upgrade to a dual-cartridge housing or a housing with a higher flow rate if they tow a large RV or have multiple people using water at once. A single-cartridge housing might not keep up with demand, causing pressure loss even with a clean cartridge. Dual housings let you run two cartridges in parallel, doubling flow capacity.
If you are replacing the housing, the job is straightforward: unscrew the old one from the inlet, screw the new one on, and install a cartridge. Most housings come with a new gasket. Use plumber's tape on the inlet threads to prevent leaks.
Frequently Asked Questions
Can I use any cartridge in my RV water filter housing?
No. Cartridges come in specific sizes — 10-inch and 20-inch are most common — and they must fit inside your housing. Check your housing label or measure the old cartridge before buying. Using the wrong size means water bypasses the cartridge entirely and you get no filtration.
How often should I replace my filter cartridge?
It depends on water quality and use. Cartridges typically last 3 to 12 months. If you notice low pressure, cloudy water, or bad taste, replace it. Many RV owners replace cartridges seasonally or before long trips as routine maintenance, regardless of how much they have been used.
What happens if I do not replace a clogged cartridge?
A clogged cartridge reduces water pressure and may trigger the bypass valve, which lets unfiltered water into your tank. You lose the protection the filter provides, and sediment or chlorine can damage your water pump or affect taste. Replacing the cartridge is inexpensive compared to repairing a pump.
Do I need a water filter housing on my RV?
It is not required, but it is strongly recommended. Campground water varies in quality, and a filter protects your fresh water tank, pump, and plumbing from sediment and chlorine. If you stay at high-quality campgrounds with consistently clean water, you might skip it, but most RV owners find the cost of a housing and cartridges worth the protection.
Can I install a water filter housing myself?
Yes. It screws onto your exterior water inlet with no tools other than a wrench. If you are not comfortable working with plumbing connections, ask a campground host or RV technician to do it. The job takes 15 minutes once you have the right housing and cartridge.