Electric tankless water heaters give you hot water on demand in an RV, but they draw heavy power and work best as a backup to propane

An electric tankless water heater heats water when ready as it flows through the unit, rather than storing hot water in a tank. In an RV, this means you can run a shower or fill a sink without waiting for water to warm up. The trade-off is straightforward: electric units need 30 to 50 amps of 120-volt or 240-volt power, which strains most RV electrical systems. Most RV owners use electric tankless heaters as a secondary option when they're plugged into shore power at a campground, not as a primary system for boondocking.

The units themselves are compact—roughly the size of a medicine cabinet—and mount on a wall or under a cabinet. Installation involves running dedicated electrical wiring from your RV's breaker panel, which typically costs $300 to $800 in labor if you hire a technician. The heater itself runs $400 to $1,200 depending on flow rate and power rating. If you already have the wiring in place or are comfortable with basic electrical work, you can reduce installation costs significantly.

Key Takeaways

  • Electric tankless heaters require 30 to 50 amps of power and work best when your RV is plugged into shore power, not when running on batteries alone.
  • A complete installation—heater plus wiring and labor—typically costs $700 to $2,000, depending on your RV's existing electrical setup.
  • Flow rate matters: units rated for 2 to 3 gallons per minute work for showers and sinks, but cannot handle simultaneous hot water use in multiple locations.
  • Propane tankless heaters are more common in RVs because they work off-grid and draw minimal electrical power, though they cost more upfront.
  • An electric unit paired with your existing propane system gives you flexibility: propane when boondocking, electric when plugged in at a campground.

Power requirements that limit where you can use an electric tankless heater

Most RV electrical systems run on 30 amps or 50 amps total. An electric tankless heater that draws 30 to 50 amps by itself leaves almost nothing for your refrigerator, air conditioning, or other appliances. This is why they only work reliably when you're plugged into a campground's shore power pedestal, which supplies unlimited power as long as you're connected.

If your RV has a 50-amp service (two 50-amp legs), you have more flexibility. A 240-volt heater can draw 30 to 40 amps on a single leg, leaving the other leg available for other systems. A 120-volt heater draws from one leg only, but still consumes enough power that you cannot run major appliances simultaneously. Check your RV's electrical panel and shore power inlet before buying—the heater must match your system's voltage and available amperage.

Battery power is not an option. Even a small electric tankless heater would drain an RV battery bank in minutes. If you want hot water while boondocking, a propane tankless heater or a traditional propane water heater tank is the practical choice.

Flow rate and how many fixtures you can use at once

Electric tankless heaters are rated by gallons per minute (GPM) at a given temperature rise. A unit rated for 2 GPM at a 40-degree rise will heat cold water from 40°F to 80°F at 2 gallons per minute. Most RV models range from 1.5 to 3 GPM, which is enough for a shower or to fill a sink, but not both simultaneously.

If you run a shower (typically 2 to 2.5 GPM) and someone turns on the galley sink at the same time, the heater cannot maintain temperature. The water will either slow to a trickle or cool down noticeably. This is a real limitation in an RV where space is tight and multiple people might need hot water at the same time. Propane tankless heaters have the same constraint, but they handle it slightly better because they can modulate flame more smoothly than electric elements can modulate power.

For a solo traveler or a couple, a 2 to 2.5 GPM electric unit is usually sufficient. For families or groups, you may need to accept that only one hot water fixture runs at a time, or upgrade to a propane system with a larger tank.

Installation: wiring, venting, and whether to hire a technician

Installation requires three main steps: running a dedicated electrical circuit from your breaker panel to the heater location, mounting the unit securely, and connecting the water inlet and outlet lines. Unlike propane heaters, electric units do not need venting because they produce no exhaust.

The electrical work is the most critical part. The circuit must be sized to the heater's amperage draw—a 30-amp heater needs a 30-amp breaker and 10-gauge wire, a 40-amp heater needs 40-amp breaker and 8-gauge wire. Running undersized wire or using the wrong breaker creates a fire hazard. If you are not confident with electrical work, hire an RV technician. Most charge $50 to $100 per hour, and a full installation typically takes 3 to 5 hours, so budget $300 to $800 in labor.

Water connections are simpler: you need flexible hoses rated for hot water, a shut-off valve on the inlet side, and proper fittings. Most heaters come with basic instructions, and the connections are similar to replacing a standard water heater. If you are doing the work yourself, buy a heater that includes a wiring diagram and installation manual specific to RVs.

Cost comparison: electric versus propane tankless heaters

FeatureElectric TanklessPropane Tankless
Unit cost$400–$1,200$800–$2,000
Installation labor$300–$800$400–$1,200
Total installed cost$700–$2,000$1,200–$3,200
Power requirement30–50 ampsMinimal (ignition only)
Works off-gridNoYes
Fuel cost per gallonElectricity (varies by region)Propane ($2–$4 per gallon)
Best use caseCampground with shore powerBoondocking or full-time travel

Electric tankless heaters cost less upfront but only work when plugged in. Propane tankless heaters cost more but work anywhere and draw almost no electrical power. If you camp primarily at RV parks with full hookups, an electric unit saves money. If you boondock frequently or want year-round hot water independence, propane is the better choice.

A hybrid approach—keeping your existing propane system and adding an electric heater for campground use—is also common. This gives you flexibility without replacing working equipment. The electric unit becomes a convenience feature rather than your primary hot water source.

Maintenance and reliability of electric tankless systems

Electric tankless heaters have fewer moving parts than propane models, so they tend to be reliable if installed correctly. The main maintenance task is descaling—flushing the unit with a vinegar solution every 6 to 12 months if you have hard water. Mineral buildup inside the heating chamber reduces efficiency and can eventually block water flow.

Most units have a replaceable inlet filter that catches sediment. Check and rinse this filter every few months, especially if your RV's water system is new or if you fill from unfamiliar sources. If the heater suddenly produces less hot water or takes longer to heat, descaling is usually the first fix to try.

Electrical connections can loosen over time due to vibration while traveling. Before each trip, visually inspect the breaker and wiring connections at your RV's electrical panel. Loose connections generate heat and can cause a breaker to trip repeatedly. If a breaker keeps tripping, stop using the heater and have a technician inspect the circuit before using it again.

Frequently Asked Questions

Can I run an electric tankless heater and my air conditioner at the same time?

Not reliably on a 30-amp service. Both draw heavy power, and running them together will trip your breaker. On a 50-amp service with a 240-volt heater, you may be able to run both if the campground's pedestal can supply the total load, but it is tight. Check your RV's electrical manual or ask the campground host before trying.

What size electric tankless heater do I need for a shower?

A 2 to 2.5 GPM unit is standard for RV showers. This assumes incoming water temperature of 50°F or higher. If you camp in cold climates where water is colder, a larger unit (3 GPM) will maintain better temperature. Test the unit at your first campground to see if the water stays hot throughout a shower.

Can I install an electric tankless heater myself?

Water connections are straightforward, but electrical work requires knowledge of circuit sizing, wire gauges, and breaker ratings. Mistakes create fire hazards. If you are experienced with RV electrical systems, you can do it. Otherwise, hire a technician. The labor cost is worth the safety assurance.

Will an electric tankless heater work with my existing propane system?

Yes. Both can coexist in the same RV. You can set your water heater to propane mode for boondocking and switch to electric when plugged in at a campground. Some RVs have a selector valve that lets you choose which system supplies hot water; others run both simultaneously, with the electric heater taking priority when power is available.

What happens if the power goes out at the campground?

The electric heater stops working when ready. If you have a propane water heater as backup, you will still have hot water. If the electric unit is your only heater, you will have no hot water until power is restored. This is another reason many RV owners keep a propane system as their primary source.