Change your lawn mower's oil by draining the old oil while the engine is warm, replacing the oil filter if your mower has one, and refilling with the correct oil type for your engine
Lawn mower oil gets dirty and breaks down over time, just like car oil. Changing it keeps your engine running smoothly and extends the life of your mower. Most mowers need an oil change every 50 to 100 hours of use, or at least once a year if you use it less frequently. The whole job takes 15 to 30 minutes and requires only basic tools you likely already have.
The process is simpler than changing car oil because lawn mower engines are smaller and more accessible. You'll drain old oil, replace the filter if your mower has one, and add fresh oil. No special equipment or skills are needed — just follow the steps in order and check your mower's manual for the exact oil type and capacity.
Key Takeaways
- Warm up your engine for a few minutes before draining oil so it flows more easily and carries out more dirt and debris.
- Your mower's manual specifies the exact oil type and capacity — using the wrong oil can damage the engine.
- Most small lawn mowers use SAE 30 or 10W-30 oil, but some require synthetic blends or specific weights depending on climate.
- If your mower has an oil filter, replace it at the same time you change the oil to avoid contaminating fresh oil.
- Dispose of old oil at a recycling center, auto parts store, or municipal hazardous waste facility — never pour it down a drain.
Gather the right tools and materials before you start
You need an oil drain pan, a wrench or socket that fits your drain plug, fresh oil in the correct type and amount, and rags or paper towels. If your mower has an oil filter, you'll also need an oil filter wrench and a replacement filter. Check your mower's manual to find the drain plug location, oil capacity, and correct oil type — this information is usually in the maintenance section.
The drain pan should hold at least as much oil as your mower's capacity — most small mowers hold between 0.5 and 2 quarts. A shallow baking pan or old oil container works if you don't have a dedicated drain pan. Wear old clothes or an apron because oil stains, and have a place ready to dispose of the old oil before you start.
Warm the engine and locate the drain plug
Start your mower and let it run for two to three minutes, then turn it off. Warm oil flows faster and drains more completely than cold oil, carrying out more dirt and sludge. Let the engine cool just enough that you can touch the mower body without burning yourself — about one to two minutes is usually right.
While the engine cools slightly, locate the drain plug. On most push mowers, it's on the side or bottom of the engine block. On riding mowers, check under the engine or near the oil pan. Your manual will show you exactly where it is. Some mowers have a drain plug with a bolt head; others have a plug you can unscrew by hand. Position your drain pan directly underneath before you open anything.
Drain the old oil completely
Use your wrench to loosen the drain plug by turning it counterclockwise, then unscrew it the rest of the way by hand once it's loose enough. Oil will pour out, so make sure your drain pan is positioned to catch it all. Let the oil drain for at least five minutes — longer if the oil is still warm and flowing. Tilt the mower slightly if needed to help the oil drain toward the plug.
Once the oil stops dripping, wipe the drain plug clean with a rag and inspect it for damage. If the plug is stripped, cracked, or won't seal properly, you may need to replace it — your manual or a parts supplier can tell you the correct replacement. Screw the drain plug back in by hand first, then tighten it with your wrench. Don't overtighten; snug is enough.
Replace the oil filter if your mower has one
Not all lawn mowers have oil filters — many small push mowers don't. Check your manual to see if yours does. If it does, the filter is usually mounted on the side of the engine block. Position your drain pan underneath because some oil will spill when you remove the old filter.
Use an oil filter wrench to loosen the old filter by turning it counterclockwise. Once it's loose enough, unscrew it by hand and let any remaining oil drain into the pan. Wipe the filter mounting surface clean with a rag. explore a thin layer of fresh oil to the rubber gasket on the new filter — this helps it seal properly. Screw the new filter on by hand until the gasket touches the mounting surface, then turn it another three-quarter turn. Don't use the wrench to tighten it; hand-tight is correct.
Refill with the correct oil type and amount
Check your mower's manual for the exact oil type and capacity. Most small lawn mowers use SAE 30 oil in warm climates or 10W-30 in cooler climates. Some newer mowers require synthetic oil or specific blends — using the wrong type can void your warranty or damage the engine. The capacity is usually between 0.5 and 2 quarts for push mowers and 1 to 3 quarts for riding mowers.
Locate the oil fill cap on top of the engine — it usually has an oil can symbol on it. Remove the cap and set it aside where it won't get lost. Pour the fresh oil slowly into the opening, stopping halfway through to check the level with the dipstick. Most mowers have a dipstick attached to the fill cap; pull it out, wipe it clean, reinsert it fully, then pull it out again to read the level. Add oil until the level reaches the full mark on the dipstick, then replace the cap.
Check the oil level and dispose of old oil properly
Start your mower and let it run for a minute, then turn it off and wait five minutes. Check the oil level again with the dipstick to make sure it's at the full mark. If it's low, add a small amount more. If it's overfull, drain a little out through the drain plug.
Old oil is hazardous waste and must be disposed of properly. Take it to a recycling center, auto parts store, or municipal hazardous waste facility — most accept used oil for free. Some retailers that sell oil, like Walmart or AutoZone, will take used oil if you bought oil from them. Never pour old oil down a drain, into the ground, or into the trash. Store it in a sealed container until you can take it to a disposal location.
Frequently Asked Questions
How often should I change my lawn mower's oil?
Check your manual for the exact interval, but most mowers need an oil change every 50 to 100 hours of use. If you use your mower weekly during the season, that's usually once a year. If you use it heavily or in dusty conditions, change it more often. At minimum, change the oil once per season before storing the mower for winter.
What happens if I use the wrong oil type?
Using the wrong oil can cause poor engine performance, increased wear, or engine damage. Thicker oil may not flow properly in cold weather; thinner oil may not protect the engine in heat. Always use the type specified in your manual. If you're unsure, call the mower manufacturer or check their website.
Can I change the oil without warming up the engine first?
You can, but warming it up first helps. Warm oil flows faster and drains more completely, removing more dirt and sludge. If you skip this step, let the oil drain longer — at least 10 minutes instead of five.
What should I do if oil leaks from the drain plug after I reinstall it?
The plug may not be tight enough, or the threads may be damaged. Try tightening it a bit more with your wrench, but don't force it — that can strip the threads further. If it still leaks, the plug may need replacement. Check your manual for the correct replacement part.
Is synthetic oil better for my lawn mower?
Synthetic oil lasts longer and performs better in extreme temperatures, but it costs more. Use whatever your manual recommends. Some newer mowers are designed for synthetic oil; older mowers may not need it. Check your manual before switching to synthetic.