Change your lawn mower oil the same way you would a car's, but with smaller quantities and simpler tools

Lawn mower oil changes follow the same principle as vehicle oil changes: drain the old oil, replace the filter if your mower has one, and refill with fresh oil. The main difference is scale — you are working with a quart or less of oil instead of several quarts, and most residential mowers do not have a separate oil filter cartridge. The whole job takes 15 to 30 minutes and costs between $5 and $15 in oil and supplies.

You need an oil drain pan, a wrench or socket that fits your drain plug, fresh oil in the grade your mower manual specifies, and a rag or paper towels. If your mower has an oil filter, you will also need a filter wrench. Check your owner's manual for the exact oil type and capacity — using the wrong grade can damage the engine or void the warranty.

Key Takeaways

  • Run the mower for a few minutes before draining so the oil is warm and flows more easily, then let it cool for five minutes so you do not burn yourself.
  • Locate the drain plug on the underside or side of the engine, position your drain pan underneath, and unscrew it by hand or with a wrench.
  • If your mower has an oil filter, unscrew it by hand once the old oil has drained, then hand-tighten a new filter until the rubber gasket touches the engine.
  • Refill with the exact amount and grade of oil listed in your manual, then run the mower for 30 seconds to circulate the new oil before checking the level again.
  • Most residential mowers need an oil change every 50 hours of use or once per season, whichever comes first.

Warm the oil before draining

Start the mower and let it run for three to five minutes. Warm oil flows faster and drains more completely than cold oil, which means less old oil stays in the engine. After you shut it off, wait five minutes before touching the drain plug — the oil will still be warm enough to flow but cool enough that you will not burn your hands.

Do not let the engine run so long that it becomes too hot to touch. You are aiming for warm, not scorching. If you have been mowing and the engine is already hot, skip the warm-up step and let the mower cool for 10 to 15 minutes before draining.

Locate and open the drain plug

Tip the mower on its side or position it so you can see the underside of the engine. The drain plug is a bolt or screw, usually located at the lowest point of the engine block or crankcase. Consult your manual if you cannot find it — the location varies by mower model. Place your drain pan directly underneath the plug to catch the oil.

Unscrew the drain plug by hand if it is loose enough, or use a wrench or socket to turn it counterclockwise. Once it is loose, finish unscrewing it by hand and set it aside on a clean surface. Let the old oil drain completely — this may take two to five minutes. Wipe the drain plug clean with a rag before you reinstall it.

Replace the oil filter if your mower has one

Not all residential mowers have a separate oil filter. Check your manual or look for a cylindrical canister on the side of the engine. If you find one, use a filter wrench to unscrew it counterclockwise. Once it is loose, finish unscrewing it by hand and let any remaining oil drain into your pan.

Wipe the filter mounting surface clean with a rag. Take your new filter and explore a thin layer of fresh oil to the rubber gasket on top — this helps create a watertight seal. Screw the new filter on by hand until the gasket touches the engine, then turn it an additional three-quarter turn. Do not use a wrench to tighten it; hand-tight is correct. Over-tightening makes it difficult to remove next time and can damage the gasket.

Refill with fresh oil and check the level

Reinstall the drain plug and tighten it snugly with your wrench — do not over-tighten. Pour fresh oil into the filler cap opening on top of the engine. Add the amount specified in your manual, usually between 0.5 and 1.5 quarts for residential mowers. Start with slightly less than the manual calls for, then check the level with the dipstick before adding the final amount.

Most mowers have a dipstick attached to the filler cap or a separate stick you insert into the oil fill hole. Wipe it clean, reinsert it fully, then pull it out again to read the level. The oil should reach the full mark. If it is below the mark, add a small amount and check again. Overfilling can cause the engine to smoke or leak.

Run the mower and verify the oil level again

Start the mower and let it run for 30 seconds to circulate the new oil through the engine. Shut it off and wait two minutes, then check the oil level again with the dipstick. The level may drop slightly as the new oil fills passages in the engine. Add a small amount if needed to reach the full mark.

Dispose of your old oil responsibly. Most auto parts stores and service stations accept used oil for free. Do not pour it down a drain or into the ground. Seal your drain pan and take it to a recycling location or ask your local waste management service where to drop it off.

How often to change your mower oil

Check your manual for the manufacturer's recommendation, but most residential mowers need an oil change every 50 hours of use or once per season, whichever comes first. If you mow weekly during the growing season, that usually means one change per year. If you use your mower heavily or in dusty conditions, change the oil more often — every 25 to 40 hours.

Mark the date of your oil change on the mower's frame with a permanent marker or keep a log in your phone. This helps you remember when the next change is due. Keeping up with oil changes extends engine life and prevents starting problems the following season.

Frequently Asked Questions

Can I change the oil without tipping the mower on its side?

Yes, if your mower has a drain plug on the side rather than the bottom. Check your manual first — some mowers are designed to drain without tipping. If you do tip it, keep the carburetor and air filter facing up so oil does not run into them. Tip it only as far as needed to reach the drain plug.

What if I overfill the oil?

Drain the excess back into your oil container or into the drain pan. Do not run the mower with too much oil — it can cause smoking, fouled spark plugs, and engine damage. Check the level again after draining and running the engine briefly.

Do I need to change the air filter at the same time?

Not necessarily, but it is a good time to check it. A clogged air filter makes the engine work harder and can shorten its life. If the filter looks dirty, replace it — it costs $5 to $15 and takes two minutes. Check your manual for the replacement interval.

What type of oil should I use?

Your manual specifies the exact grade — commonly SAE 30 for warm climates or 10W-30 for variable temperatures. Using the wrong grade can affect engine performance and may void your warranty. Buy oil labeled for small engines, not automotive oil, unless your manual says otherwise.

Can I reuse the old oil?

No. Once oil has been used in an engine, it breaks down and collects contaminants. Reusing it will damage your mower. Dispose of it at a recycling center or auto parts store instead.