Motor mount replacement typically runs between $300 and $1,500 per mount, depending on which mount fails, your vehicle's make and model, and whether the job requires engine removal

A single motor mount costs $150 to $600 in parts, plus $150 to $900 in labour. The wide range exists because some mounts sit in straightforward-to-reach spots—your mechanic can swap one in under an hour—while others require dropping the engine or removing the transmission to access. A four-cylinder sedan might need $400 total for one mount; a luxury SUV with the same mount might cost $1,200 because the engine sits lower or the transmission blocks access.

If multiple mounts have failed—which often happens together because they wear at similar rates—you're looking at $800 to $3,000 or more. Most vehicles have three to four motor mounts, and replacing all of them at once costs less per mount than doing them one at a time, because the labour setup happens only once.

Key Takeaways

  • Motor mount replacement labour ranges from one hour to six hours depending on location and engine design, which is why quotes vary so widely even for the same vehicle year and model.
  • Parts cost $150 to $600 per mount, and labour typically adds $150 to $900, but some vehicles require engine removal, which can double or triple the labour bill.
  • Replacing all worn mounts at once is cheaper per mount than replacing them individually, because the initial disassembly work applies to all of them.
  • Delaying motor mount replacement risks damage to the transmission, engine block, and suspension components when the engine rocks excessively during acceleration or braking.

Why motor mount location determines your repair bill

Motor mounts bolt the engine to the frame and absorb vibration and movement. Most vehicles have three or four mounts: two on the sides (left and right), one at the rear, and sometimes one at the front. The side mounts are usually the easiest to reach and cost the least to replace. The rear mount often requires removing the transmission or dropping the engine, which adds hours of labour.

A Honda Civic's side mount might take 45 minutes and cost $400 total. The same Civic's rear mount might take three hours and cost $800, because the transmission has to come out of the way. A luxury vehicle with a transverse engine (engine mounted sideways) or a tight engine bay can make even the "straightforward" mounts difficult to access. Always ask your mechanic which mount has failed before accepting a quote—the location matters more than the vehicle's age or mileage.

Labour time and shop rates affect your final bill

Motor mount replacement labour is priced by the hour, and shop rates vary by region and shop type. Independent shops typically charge $80 to $150 per hour. Dealerships charge $120 to $200 per hour. A job that takes one hour at an independent shop costs $80 to $150; the same job at a dealership costs $120 to $200. A three-hour job that requires engine removal costs $240 to $450 at an independent shop or $360 to $600 at a dealership.

Some shops quote a flat rate for motor mount replacement based on their experience with your specific vehicle. Flat-rate quotes are often more predictable than hourly estimates, but they assume the job goes smoothly. If your mechanic discovers rust, broken bolts, or engine damage during removal, the flat rate may not hold, and you'll be charged for additional time.

Parts prices vary by mount type and manufacturer

OEM (original equipment manufacturer) motor mounts—the parts made by your vehicle's manufacturer—typically cost $200 to $400 per mount. Aftermarket mounts made by companies like Prothane, Energy Suspension, or DEA cost $150 to $300. The difference is usually in durability and noise isolation. OEM mounts are engineered to match your engine's weight and vibration signature exactly. Aftermarket mounts may be stiffer or softer, which can change how much vibration you feel in the cabin.

Hydraulic mounts (which contain fluid to dampen vibration) cost more than solid rubber mounts and are more common in luxury vehicles. A hydraulic mount can cost $300 to $600 alone. If your vehicle originally had hydraulic mounts, replacing them with cheaper solid mounts will reduce vibration isolation and may void your warranty or cause transmission damage over time.

Engine removal adds significant cost and time

Some vehicles require engine removal to access rear or lower motor mounts. Engine removal typically adds 4 to 8 hours of labour and costs $400 to $1,600 in additional labour alone. During removal, your mechanic will also drain fluids, disconnect dozens of hoses and electrical connectors, and remove the radiator, fan, and sometimes the transmission. If anything breaks during removal—a connector, a hose, a bolt—the repair bill grows.

Before accepting an engine-removal quote, ask your mechanic whether the mount can be replaced without full removal. Some shops can access rear mounts by removing the transmission alone, which takes 2 to 4 hours instead of 6 to 8. Others can use a jack and engine support bar to lift the engine enough to slide the mount out. These alternatives cost less but require skill and the right equipment.

What happens if you delay motor mount replacement

A failed motor mount allows the engine to rock excessively during acceleration, braking, and turning. This movement stresses the transmission mounts, engine block, radiator hoses, and suspension components. Over weeks or months, the engine can contact the frame or transmission, causing cracks in the engine block or transmission case. These repairs cost $2,000 to $5,000 or more and are far more expensive than replacing the motor mount when it first fails.

Excessive engine movement also accelerates wear on other mounts. If one mount has failed, the others are carrying extra load and will fail sooner. Replacing all worn mounts together prevents a cascade of failures and saves money on labour, because the mechanic does the disassembly work only once.

Getting an accurate quote for your vehicle

Call or visit three shops and describe your symptoms: clunking sounds during acceleration, visible engine movement, or a rough idle. Tell them which mount you suspect has failed, if you know. Ask for a written estimate that includes the part cost, labour hours, and the shop rate. Ask whether the quote includes fluid top-ups or hose replacements if those are disturbed during the job.

If one quote is significantly lower than the others, ask why. The shop may use cheaper aftermarket parts, charge a lower labour rate, or have found a faster way to access the mount. If one quote is significantly higher, ask whether it includes engine removal or additional repairs. A quote that's $500 higher because it includes transmission removal is not necessarily a bad deal if that work is necessary.

Frequently Asked Questions

Can I drive with a bad motor mount?

Yes, but not safely for long. A failed mount causes excessive engine movement, which stresses the transmission, radiator hoses, and engine block. You may hear clunking or feel the engine rock during acceleration. Continuing to drive risks damage to the transmission or engine, which costs far more to repair than the motor mount itself.

Do all motor mounts fail at the same time?

Not always, but they often fail within a few thousand miles of each other because they wear under the same conditions. If one mount has failed, the others are carrying extra load and will fail sooner. Many mechanics recommend replacing all mounts together to avoid repeat visits and to spread the labour cost across multiple parts.

Is there a difference between OEM and aftermarket motor mounts?

OEM mounts are engineered for your specific engine and usually provide better vibration isolation. Aftermarket mounts are cheaper but may be stiffer or softer, which can change how much vibration you feel in the cabin. If your vehicle originally had hydraulic mounts, replacing them with solid mounts may reduce performance and durability.

Why does engine removal cost so much?

Engine removal requires disconnecting dozens of hoses, electrical connectors, and bolts, draining fluids, and removing the radiator, fan, and sometimes the transmission. The job typically takes 6 to 8 hours. Ask your mechanic whether the mount can be accessed without full engine removal, as some shops can use a jack and support bar to lift the engine instead.

Will my warranty cover motor mount replacement?

Factory warranties typically cover motor mounts for three years or 36,000 miles, whichever comes first. Extended warranties may cover them longer. Check your warranty paperwork or contact your dealership to confirm coverage. If your vehicle is out of warranty, the full cost falls to you.