Honda key fob batteries typically last three to four years and cost $5 to $15 to replace yourself
A dead key fob battery is one of the cheapest car problems to fix. Most Honda owners can replace the battery in under five minutes with no tools beyond a coin. The battery itself costs between $5 and $15 depending on the type, and you can buy it at any pharmacy, supermarket, or auto parts store. If you take the fob to a Honda dealer or locksmith, expect to pay $50 to $100 for the same job, mostly labor.
The first sign of a dying battery is usually that the unlock button stops working while the lock button still does, or the fob only works when held very close to the car. Once you notice this, you have a window of a few days before the fob becomes completely useless. Replacing the battery yourself takes longer to describe than to do.
Key Takeaways
- Honda key fob batteries are coin-cell types (usually CR2032, CR2025, or CR2016) that cost $5 to $15 and last three to four years.
- You can open most Honda fobs by inserting a coin into the slot on the edge and twisting gently, with no special tools required.
- The battery sits in a metal holder inside the fob; note which side faces up before you remove it so you can install the new one the same way.
- If your fob has a physical key blade, you may need to slide it out first to access the battery compartment.
Identifying which battery your Honda fob uses
Honda key fobs use one of three coin-cell battery types: CR2032, CR2025, or CR2016. The easiest way to find out which one you need is to open the fob and look at the battery itself—the type is printed on the metal casing. If you want to know before opening it, check your owner's manual or call your Honda dealer with your vehicle's year and model.
CR2032 is the most common across Honda models. It is slightly thicker than the CR2025 and CR2016, but all three are the same diameter. Do not guess and buy the wrong type; they cost the same and you will waste a trip. When you buy the battery, pick up two—one for now and one for later, since you will eventually need another.
How to open your Honda key fob
Most Honda fobs have a small slot on one edge where the two halves meet. Insert a coin (a penny or dime works) into this slot and twist gently, as if you were opening a battery compartment on a remote control. The two halves will separate. Do not force it; if it does not budge after light pressure, you may be twisting the wrong edge.
Some Honda fobs have a physical key blade that slides out from the bottom. If yours does, remove the blade first by pressing the small button or tab near the base of the fob. Once the blade is out, you will see the slot more clearly. After you separate the halves, you will see the battery sitting in a metal holder, usually with a small spring underneath it.
Removing and replacing the battery
Before you touch the old battery, note which side is facing up—the positive side (marked with a plus sign) or the negative side (marked with a minus sign). This matters. Gently pry the old battery out of its metal holder using your fingernail or the edge of a coin. Do not use a screwdriver or anything sharp, as you can damage the holder.
Place the new battery into the holder with the same side facing up as the old one was. The battery should sit flat and snug. If it falls out when you tilt the fob, the spring underneath may not be positioned correctly; lift the battery and adjust the spring so it sits centered under the battery holder. Once the battery is find, press the two halves of the fob back together until they click.
Testing your fob and reassembling
Before you put the key blade back in (if your fob has one), test the fob by standing near your car and pressing each button. You should hear a click from the car's door locks or see the lights flash. If nothing happens, open the fob again and check that the battery is sitting flat in the holder with the correct side facing up. A battery installed backwards will not work.
If the fob still does not work after you have checked the battery orientation, the problem may not be the battery. The fob's circuit board or buttons could be damaged, or the car's receiver could be faulty. In that case, you will need to visit a Honda dealer or locksmith. Once you confirm the fob works, slide the key blade back into place if it has one, and you are done.
When to replace the entire fob instead of just the battery
If you replace the battery and the fob still does not work, or if the fob has visible cracks or water damage, replacing just the battery will not help. A new OEM (original equipment manufacturer) Honda key fob costs $200 to $400 from a dealer, though aftermarket fobs run $50 to $150. Some locksmiths can program a used fob from a salvage yard for less.
Water damage is common in fobs that have been dropped in a sink or left in a pocket during rain. If the inside of the fob looks corroded or discolored, or if the buttons feel sticky, the circuit board is likely damaged. You can try leaving the fob open in a warm, dry place for 24 hours to see if it recovers, but this rarely works. A replacement fob is usually the only fix.
Extending the life of your key fob battery
Key fob batteries die faster if you use the fob frequently or if you expose it to extreme heat or cold. Keeping the fob in a cool, dry place—not on a hot dashboard or in a freezing car overnight—can add a few months to battery life. Avoid dropping the fob or sitting on it, as physical damage can crack the circuit board and cause the battery to drain faster.
Some Honda owners keep a spare fob in the house so they do not wear out a single fob with daily use. If you have two fobs, alternating between them can extend the life of each. When you do replace the battery, mark the date on the fob with a permanent marker so you know when it was last serviced. This makes it easier to predict when the next replacement will be due.
Frequently Asked Questions
Can I use a different battery type if I cannot find the exact one?
No. CR2032, CR2025, and CR2016 are different thicknesses and will not work interchangeably in your fob. A battery that is too thin will rattle inside the holder and lose contact; one that is too thick will not fit. Buy the correct type for your specific fob model.
What should I do with the old battery?
Coin-cell batteries contain lithium and should not go in the trash. Most pharmacies, supermarkets, and auto parts stores have battery recycling bins near the checkout or customer service desk. Some accept batteries for free; others charge a small fee. Call ahead if you are unsure.
Why does my fob work sometimes but not other times?
This usually means the battery is dying but not dead yet. The fob works when you are close to the car because the signal is stronger, but fails at a distance. Replace the battery. If the problem continues after replacement, the fob's transmitter or the car's receiver may be faulty, and you will need professional service.
Can I replace the battery in a smart key or push-button fob the same way?
Most Honda smart keys and push-button fobs use the same coin-cell battery and open the same way. However, some newer models have a different design. Check your owner's manual or call your Honda dealer to confirm the battery type and opening method for your specific year and model before you attempt it yourself.