A Group 24 marine battery is a deep-cycle battery built to power boats and other watercraft, not a car battery adapted for water use

Group 24 refers to the physical size and terminal layout set by the Battery Council International — a 10.25-inch length, 6.8-inch width, and 8.9-inch height. Marine batteries in this size are designed to discharge slowly over hours or days, then recharge fully, which is different from the quick-burst power a car battery provides. A car battery drains itself in minutes to start an engine; a marine battery powers trolling motors, cabin lights, and navigation systems for extended periods without the engine running.

The "marine" part matters because these batteries are built to handle vibration, salt spray, and the constant motion of a boat. The cases are more durable, the terminals are corrosion-resistant, and the internal chemistry is tuned for the discharge patterns you actually encounter on the water. If you own a boat with an onboard electrical system — whether it's a fishing boat, cabin cruiser, or sailboat — a Group 24 marine battery is likely what you need, not what you might find in an auto parts store under a generic label.

Key Takeaways

  • Group 24 marine batteries are sized and designed specifically for boats, with deeper discharge cycles and better corrosion resistance than automotive batteries.
  • Marine batteries come in two main types: starting batteries (for engine ignition) and deep-cycle batteries (for trolling motors and cabin power), and many boats use both.
  • A Group 24 marine battery typically costs between $150 and $400 depending on whether it is a starting or deep-cycle model and the brand.
  • Marine batteries need periodic maintenance — checking water levels in flooded models, cleaning corrosion from terminals, and storing them properly in off-season — to last 3 to 5 years.
  • Cold cranking amps (CCA) matter for starting batteries, while amp-hour (Ah) capacity matters for deep-cycle batteries, and the two numbers serve different purposes.

Starting batteries versus deep-cycle batteries in Group 24 size

A starting battery delivers a large burst of power for a short time — exactly what you need to turn over a boat engine. It has thin internal plates and is designed to discharge only 10 to 20 percent of its capacity before recharging. If you use a starting battery like a deep-cycle battery, it will fail in a season or less because the plates will warp and separate.

A deep-cycle battery has thicker internal plates and can discharge 80 percent or more of its capacity repeatedly without damage. It delivers power more slowly but for much longer, which is what a trolling motor or cabin electrical system needs. The trade-off is that a deep-cycle battery cannot deliver the when ready cranking power an engine requires.

Many boats use both: a starting battery to crank the main engine, and one or more deep-cycle batteries to run everything else. Some boats use a single dual-purpose battery that splits the difference, but it performs neither role as well as a dedicated battery. If your boat has a trolling motor, you need a deep-cycle Group 24. If it has only an engine and basic cabin power, a starting battery may be enough — but check your boat's manual or ask the dealer which type the system was designed for.

Cold cranking amps and amp-hour capacity: what the numbers mean

Cold cranking amps (CCA) is the amount of current a starting battery can deliver for 30 seconds at 0°F while maintaining at least 7.2 volts. It is the number you see on starting batteries, and it tells you how hard the battery can work in cold conditions. A Group 24 starting battery typically ranges from 500 to 750 CCA. Higher CCA means faster engine cranking, especially in winter or in cold water.

Amp-hour (Ah) capacity is the amount of current a battery can deliver over time — usually measured as the current it can sustain for 20 hours before dropping to 10.5 volts. A Group 24 deep-cycle battery typically ranges from 70 to 110 Ah. This number tells you how long the battery will power your trolling motor or cabin systems. A 100 Ah battery powering a 50-amp load will run for about 2 hours; the same battery powering a 10-amp load will run for about 10 hours.

Do not confuse the two numbers. CCA is only useful for starting batteries. Amp-hour capacity is only useful for deep-cycle batteries. If you are shopping for a deep-cycle battery, ignore the CCA rating — it is not relevant to how long your trolling motor will run. If you are shopping for a starting battery, ignore the amp-hour rating and focus on CCA instead.

Flooded, AGM, and lithium Group 24 marine batteries

Flooded batteries (also called wet-cell batteries) have removable caps on top and require you to check and refill the water level every few months. They are the cheapest option, typically $150 to $250 for a Group 24 deep-cycle model. The downside is maintenance — if the water level drops too far, the internal plates are exposed to air and the battery fails. Flooded batteries also emit hydrogen gas when charging, so they need ventilation and should not be stored in an enclosed cabin.

AGM (absorbed glass mat) batteries have no caps and require no water refilling. The electrolyte is absorbed into a fiberglass mat, so there is nothing to spill even if the battery is tilted or damaged. AGM batteries are more expensive — typically $250 to $350 for a Group 24 deep-cycle model — but they last longer, charge faster, and can be stored in a cabin without ventilation concerns. They also perform better in cold water and hold their charge longer during off-season storage.

Lithium batteries are the newest option and the most expensive, typically $400 to $600 for a Group 24 equivalent. They are lighter, charge much faster, and last 10 years or more instead of 3 to 5. The catch is that lithium batteries require a compatible charger and a battery management system to prevent damage. If your boat's charging system is designed for lead-acid batteries (flooded or AGM), a lithium battery may not work without upgrades. Check your boat's manual or charger specifications before buying.

How to maintain a Group 24 marine battery

For flooded batteries, check the water level every month during the boating season. The water should cover the internal plates by about half an inch. If it is low, add distilled water only — tap water contains minerals that shorten battery life. Do not overfill; water expands when the battery charges, and overfilled batteries leak acid.

For all battery types, clean the terminals and cable connections every few months. Corrosion (a white, blue, or green crusty buildup) increases resistance and reduces power delivery. Disconnect the negative cable first, then the positive cable. Scrub the terminals with a wire brush or a battery terminal cleaner, then reconnect the positive cable first, then the negative cable. This order prevents accidental short circuits.

During off-season storage, disconnect the battery from the boat's electrical system to prevent slow discharge. Store it in a cool, dry place — not in direct sunlight or in a freezing garage. If you store the boat for more than a month, charge the battery fully before storage, then charge it again every 30 days. A trickle charger or battery maintainer (a low-amp charger that turns itself on and off) is the easiest way to do this without overcharging.

Replacing a Group 24 marine battery: cost and timing

A new Group 24 marine battery costs between $150 and $600 depending on the type. Flooded deep-cycle batteries are the cheapest at $150 to $250. AGM deep-cycle batteries run $250 to $350. Starting batteries (flooded or AGM) are similar in price to deep-cycle models. Lithium batteries are the most expensive at $400 to $600, but they last much longer and require less maintenance.

Most marine batteries last 3 to 5 years with regular maintenance. Flooded batteries tend to fail sooner if water levels are neglected. AGM batteries last longer because they do not dry out. Lithium batteries can last 10 years or more if the charging system is compatible. If your battery is more than 5 years old and losing charge quickly, replacement is usually cheaper than repair.

Installation is straightforward: disconnect the negative cable, then the positive cable, remove the old battery, set the new one in place, reconnect the positive cable first, then the negative cable. If your boat has multiple batteries, label the cables before disconnecting so you do not mix them up. Most marine dealers and auto parts stores will install a battery for free or a small fee if you buy it from them.

Choosing between Group 24 and other battery sizes for your boat

Group 24 is a mid-size battery. Smaller boats and kayaks with minimal electrical systems might use Group 27 or Group 31 batteries, which are physically larger and hold more charge. Larger boats with heavy electrical loads often use multiple Group 24 batteries wired in parallel (positive to positive, negative to negative) to increase total capacity without increasing voltage.

If your boat came with a Group 24 battery, stick with Group 24 unless you are upgrading the entire electrical system. The battery box, cable lengths, and charging system are all sized for that battery. Switching to a larger battery may require new cables, a new charger, or modifications to the battery box. If you are unsure what size your boat needs, check the owner's manual or ask the dealer — the manual will specify the battery group and type.

Frequently Asked Questions

Can I use a car battery in my boat?

Not as a primary power source. Car batteries are designed for quick cranking, not the slow discharge cycles a boat needs. A car battery will fail in weeks if used to power a trolling motor or cabin lights. You can use a car battery as a temporary starting battery in an emergency, but replace it with a proper marine battery as soon as possible.

How do I know if my Group 24 marine battery is dead?

A dead or dying battery will not crank the engine, or will crank very slowly. Cabin lights will be dim or will not turn on. A multimeter will show voltage below 12 volts when the engine is off. If the battery is more than 5 years old and shows these signs, replacement is usually the answer. If it is newer, the charger or charging system may be the problem instead.

Should I buy a starting battery or deep-cycle battery for my boat?

Check your boat's manual or ask the dealer. If your boat has a trolling motor, you need a deep-cycle battery. If it has only an engine and basic lights, a starting battery is enough. Many boats use both — a starting battery for the engine and a deep-cycle battery for everything else. Using the wrong type will shorten battery life significantly.

Can I charge a marine battery with a car charger?

Yes, if the charger is a standard lead-acid charger and the battery is flooded or AGM. Set the charger to 12-volt mode and use a low amp setting (5 to 10 amps) to avoid overcharging. Do not use a car charger on a lithium battery unless the charger is specifically rated for lithium. Lithium batteries need a compatible charger to prevent damage to the battery management system.

What is the difference between a marine battery and a deep-cycle battery?

A deep-cycle battery is a type of battery designed for slow discharge. A marine battery is a deep-cycle battery built to handle the vibration, salt spray, and corrosion of a boat environment. All marine deep-cycle batteries are deep-cycle batteries, but not all deep-cycle batteries are marine-rated. For a boat, buy a battery labeled as marine to may support it has the corrosion resistance and durability you need.