When and why your car key stops working

Your car key remote stops responding for one of two reasons: the battery inside it has died, or the key fob itself has failed. A dead battery is by far the more common problem and the one you can fix yourself in under a minute. The battery in most key fobs lasts three to four years depending on how often you use the lock and unlock buttons. If your key still locks and unlocks the car but the buttons feel sluggish or only work when you press hard, the battery is nearly gone.

The second scenario—a broken key fob—happens when water gets inside, the circuit board cracks, or the buttons wear out completely. You cannot fix this yourself; you will need a replacement key from your car's manufacturer or a locksmith who programs aftermarket fobs.

Key Takeaways

  • Most car key remotes use a coin-cell battery (usually CR2032, CR2025, or similar) that costs $3 to $8 and takes 30 seconds to swap.
  • You can open most key fobs by prying gently along the seam with a flathead screwdriver or a coin, then sliding the two halves apart.
  • Note which side the battery sits on before you remove it, because putting it back upside down will prevent the key from working.
  • If the key still does not work after a fresh battery, the fob itself is damaged and you will need a replacement from your dealership or a locksmith.
  • Replacement keys range from $50 to $400 depending on your car's make and model, and whether the key includes a transponder chip.

Finding the right battery for your key fob

The battery type is printed on the inside of your key fob once you open it. Most common types are CR2032, CR2025, CR2016, and LR44. You do not need to guess—open the fob first, look at the battery, and note the number stamped on it. Then buy that exact type at any drugstore, supermarket, or hardware store. A single battery costs between $3 and $8, and a pack of two or four costs only slightly more.

Do not buy the cheapest generic brand if you can help it. Duracell, Energizer, and Panasonic batteries last longer and are worth the small extra cost. Keep a spare in your glove box once you know your key's battery type; a dead battery can strand you at the worst moment.

How to open your key fob safely

Most key fobs split into two halves along a seam that runs around the edge. Look for a small slot or gap where the two pieces meet. Slide a flathead screwdriver or a coin (a dime or penny works well) into the gap and twist gently to pry the halves apart. Do not force it—if you meet hard resistance, you are prying in the wrong spot. Rotate around the edge until you find the point where the fob wants to open.

Some fobs have a small screw holding them together instead of a snap fit. If you see a screw, use a screwdriver that fits it snugly; a screwdriver that is too small will strip the screw head and make it impossible to open. Once the fob is open, set the screws somewhere safe so you do not lose them.

A few luxury car keys (some BMW, Mercedes, and Audi models) have a sliding battery tray instead of a hinged case. Look for a small arrow or slot on the side of the fob. Slide a coin or screwdriver in the direction the arrow points, and the tray will slide out. This design is actually easier to work with than a snap-fit fob.

Removing and replacing the battery

Once the fob is open, look at how the battery sits inside. Most batteries rest in a small metal holder with a plus sign (+) facing up. Before you touch anything, take a photo of the battery in place with your phone. This takes five seconds and saves you from the frustration of putting the new battery in backwards.

Gently pry the battery out using a plastic spoon, a plastic pry tool, or the edge of a coin. Do not use a metal screwdriver directly on the battery itself, because you can create a short circuit. Once the old battery is out, drop the new one in with the plus side facing the same direction as the old one was. Press down gently until it clicks into the holder.

Close the fob by pressing the two halves together until they snap. If your fob had screws, replace them now and tighten them snugly but not so hard that you strip them. Test the key by standing near your car and pressing the lock and unlock buttons. If the buttons respond when ready and the car locks and unlocks, the battery swap worked.

What to do if a new battery does not fix the problem

If you installed a fresh battery and the key still does not work, the fob itself is damaged. Water damage is the most common cause—even a small amount of moisture inside the fob can corrode the circuit board and make the buttons unresponsive. Dropping the fob or sitting on it can crack the circuit board or break the button contacts. In either case, the fob cannot be repaired and must be replaced.

You have two options: buy a replacement from your car's dealership, or buy an aftermarket fob from a locksmith or online retailer and have it programmed. Dealership keys are more expensive but may provide to work with your car. Aftermarket keys cost less but require programming, which adds time and sometimes extra cost.

Dealership keys versus aftermarket keys and programming

A new key from your dealership costs between $50 and $400 depending on your car's year, make, and model. Luxury vehicles and newer cars with advanced security features are at the high end of that range. The dealership will program the key to your car on the spot, so you drive away with a working fob. You will need to bring your vehicle identification number (VIN) and proof of ownership.

Aftermarket key fobs cost $20 to $100 and are available online or from locksmiths. They work with most common car models, but you must have them programmed to your specific vehicle. Some locksmiths program keys for $50 to $150 on top of the fob cost. A few newer cars allow you to program a key yourself by following a sequence of steps (turning the ignition on and off, pressing buttons on the fob), but this varies by manufacturer and year. Check your owner's manual or call your dealership to ask if your car supports self-programming.

If your key includes a transponder chip—a security feature that communicates with your car's engine immobilizer—the cost rises because programming requires special equipment. Most cars made after 2000 have transponder keys. Dealerships always have the right equipment; not all locksmiths do, so ask before you commit.

Keeping your key fob in good condition

A key fob lasts longer when you keep it dry and avoid dropping it. Do not leave it in your car's cup holder or door pocket where it can get wet or crushed. Keep it in a pocket or bag where it is protected. If your fob gets wet, remove the battery when ready and let both the fob and battery dry completely in a warm, dry place for at least 24 hours before reassembling. This can sometimes save a fob that would otherwise fail.

Avoid pressing the buttons unnecessarily. Every button press wears the contacts inside the fob a little bit. If you use a keychain remote to lock your car from across a parking lot, you are wearing out the buttons faster than someone who only uses the key to unlock the door. This is not a reason to avoid using your fob, just a reality of how they age.

Frequently Asked Questions

Can I use any coin-cell battery, or does it have to be the exact type?

Use the exact type printed on the old battery. CR2032 and CR2025 look nearly identical but have different thicknesses, and using the wrong one can prevent the fob from closing properly or cause poor contact. The cost difference is negligible, so there is no reason to guess.

What if I cannot get the key fob open?

Stop prying and take the fob to a locksmith or your dealership. Forcing it risks breaking the plastic case or the circuit board inside, which turns a $5 battery swap into a $200 replacement. A locksmith can open it without damage in a few minutes.

Will my car still start if the key fob battery is dead?

Yes. Most cars have a physical key blade hidden inside the fob that you can use to unlock the door manually. Once inside, you can start the car with the blade in the ignition, even if the remote buttons are dead. Check your owner's manual to find where the blade is hidden on your specific fob.

How much does it cost to replace a key fob?

Dealership fobs range from $50 to $400 depending on your car. Aftermarket fobs cost $20 to $100, but you may need to pay a locksmith $50 to $150 to program it. Luxury vehicles and newer models with advanced security features are at the higher end of both ranges.

Can I program an aftermarket key myself?

Some cars allow self-programming by following a sequence of ignition and button presses, but this varies by manufacturer and year. Check your owner's manual or call your dealership to ask if your car supports it. If not, you will need a locksmith or dealership to program the key using specialized equipment.