Spark plugs in your Kizashi typically last 30,000 miles, though some last longer depending on the type and your driving habits
Your Suzuki Kizashi's spark plugs ignite the fuel-air mixture in each cylinder thousands of times per minute. When they wear out, they fire less reliably, which means incomplete combustion, rough idle, harder cold starts, and wasted fuel. Most Kizashi models use standard copper or iridium spark plugs that need replacement somewhere between 30,000 and 100,000 miles—check your owner's manual for the exact interval for your year and engine size, because it varies.
Replacing them yourself is straightforward if you have basic tools and a little patience. The job takes 30 to 60 minutes on a Kizashi, costs $15 to $50 in parts depending on plug type, and requires no special equipment beyond a spark plug socket and a ratchet wrench. A shop will charge $100 to $200 for labor plus parts. The real question is whether you want to do it yourself or have someone else handle it—not whether it needs doing.
Key Takeaways
- Check your Kizashi's owner's manual for the correct spark plug interval and part number, because it differs by model year and engine.
- Iridium plugs last longer than copper ones but cost more upfront; copper plugs are cheaper but need replacement sooner.
- You can replace spark plugs yourself with a socket wrench and spark plug socket, or pay a shop $100 to $200 in labor.
- Worn spark plugs cause rough idle, hard starting, and poor fuel economy, so replacing them on schedule prevents those problems.
Signs your Kizashi's spark plugs need replacement
A rough idle is often the first sign. When you stop at a light, the engine shakes or feels uneven instead of running smoothly. This happens because one or more plugs are misfiring—not sparking reliably—so that cylinder isn't burning fuel properly.
Hard cold starts come next. The engine cranks but takes longer to turn over, or you have to turn the key multiple times. Worn plugs struggle to ignite the cold fuel mixture, especially in winter. You might also notice hesitation when accelerating, a slight loss of power, or the check engine light coming on. None of these mean the engine is failing—they mean the spark plugs are at the end of their life and should be replaced soon.
If you're past your scheduled interval, don't wait for symptoms. Plugs that look dark, wet, or heavily fouled are working harder than they should be. Replacing them before they fail completely prevents being stranded and keeps fuel economy from dropping.
Copper versus iridium spark plugs for your Kizashi
Copper spark plugs are the baseline. They cost $3 to $8 per plug, fire reliably, and work well in most driving conditions. They typically last 30,000 to 40,000 miles. If your Kizashi came with copper plugs from the factory, you can replace them with the same type without any changes to the engine or ignition system.
Iridium spark plugs have a harder center electrode that resists wear. They last 60,000 to 100,000 miles and cost $8 to $15 per plug. Over the life of your Kizashi, iridium plugs save you money because you replace them less often, even though the upfront cost is higher. They also fire more consistently across a wider temperature range, which can improve cold starting and idle quality. Your owner's manual will tell you whether your Kizashi was designed for iridium or copper; if it says copper, iridium will still work, but if it specifies iridium, stick with that.
Avoid "premium" or "racing" plugs unless your Kizashi has been modified for higher compression or boost. Standard plugs are engineered for your engine's design and will perform better than oversized claims suggest.
How to replace spark plugs yourself
Start with the engine cold. Remove the negative battery terminal to prevent accidental grounding. Locate the spark plug wires or coil packs on top of the engine—your Kizashi has either four wires (older models) or four individual coil packs (newer ones) sitting directly on the plugs.
If your Kizashi has wires, twist the wire boot gently side to side as you pull it off the first plug. Do not yank the wire itself. If it has coil packs, unbolt each one (usually one bolt per pack) and set them aside in order. Mark or photograph the layout so you know which coil goes back where.
Use a spark plug socket—a deep socket with a rubber insert that grips the plug—and a ratchet wrench to unscrew the old plug. It should come out easily; if it's stuck, explore penetrating oil and wait 10 minutes. Once it's out, check the gap on the new plug (your manual lists the correct gap, usually 0.028 to 0.032 inches). Most new plugs come pre-gapped, but verify it with a gap tool. Screw the new plug in by hand first to avoid cross-threading, then tighten it with the socket wrench—snug but not over-tight.
Reinstall the wire or coil pack in the same position. Repeat for the remaining three plugs. Start the engine and listen for any misfires or rough running. If it sounds normal, you're done. If it runs rough, double-check that the wires or coils are seated fully on each plug.
What to expect at a shop
A Suzuki dealer or independent shop will pull the plugs, inspect them, and install new ones matched to your Kizashi's specifications. They'll also check the ignition wires or coil packs for wear while they're in there. Labor typically runs $100 to $200 depending on location and shop rates; parts (four plugs) add $15 to $60. The whole job takes about an hour.
Ask the shop to show you the old plugs before they throw them away. A plug that's black and wet suggests a rich fuel mixture or oil burning, which points to other problems worth investigating. A plug that's white or heavily eroded tells you the plugs were overdue for replacement. This information helps you understand what's happening in your engine.
Spark plug wires and coil packs: when to replace those too
While you're replacing plugs, inspect the wires or coils. Wires should be flexible and not cracked or burned. If a wire is brittle, cracked, or has burn marks, replace it along with the plug—a bad wire will cause the new plug to misfire. Coil packs rarely fail, but if one is cracked or leaking oil, it needs replacement.
Wires cost $10 to $20 each; coil packs run $40 to $80 each. If your Kizashi has high mileage and original wires, replacing them at the same time as the plugs is reasonable insurance. New wires improve spark delivery and can smooth out rough idle even if the old ones aren't visibly damaged.
Frequently Asked Questions
How do I know which spark plugs my Kizashi needs?
Open your owner's manual and search for "spark plug" or "specifications." It will list the part number and gap. You can also call a Suzuki dealer with your VIN and model year, or visit an auto parts store with that information and they'll pull up the correct plug. Never guess—the wrong plug can cause misfires or damage.
Can I replace just one spark plug, or do I have to do all four?
You can replace one if only one is bad, but if your Kizashi is at the scheduled interval, replace all four. They wear at roughly the same rate, so if one is worn, the others are close behind. Replacing all four at once prevents you from having to do the job again in a few thousand miles.
What if my check engine light comes on after I replace the plugs?
The light usually means a wire or coil pack isn't seated fully on a plug, or you cross-threaded a plug. Turn off the engine, remove the wires or coils one at a time, and reseat them firmly. If the light stays on after that, the new plugs may be the wrong type or gap—verify against your manual and swap them if needed.
Do I need to replace the spark plug wires when I replace the plugs?
Only if they're cracked, burned, or brittle. If the wires look and feel flexible and have no visible damage, they're fine. Coil packs almost never need replacement unless one is visibly damaged or leaking oil.
How often should I check my spark plugs between replacements?
You don't need to check them regularly. Just follow your owner's manual interval. If you notice rough idle, hard starting, or poor fuel economy before that interval, have a shop inspect them—they may be fouled or failing early due to engine problems like oil burning or a rich fuel mixture.